Assembly - Husky HOEC5210B12M Use And Care Manual

Assembly

1
Attaching the side handle
□ Attach the side handle (B) to the cabinet using four bolts
(AA).
□
Tighten all bolts with the 10 mm wrench (DD).
Do not over tighten the bolts to avoid damage to the finish.
NOTE: The holes in the cabinet are tapped and do not
require nuts.
3
Attaching the power strip brackets
□ Attach the power strip brackets (H) to the cabinet using four
bolts (EE).
□
Tighten all bolts using a screwdriver.
Do not over tighten the bolts to avoid damage to the finish.
NOTE: The holes in the cabinet are tapped and do not
require nuts.
□
AA
B
□
H
EE
2
Installing the casters
Warning: Two or more people may be required for this
step due to the weight of the workbench.
CAUTION: Do not over tighten the screws.
□
Ensure all cabinet drawers are securely locked into
place using the key (I) and lock (J) on the rolling cabinet (C).
□ Lay the rolling cabinet (C) on its back
packaging material to protect the finish.
□ Mount the two swivel casters with brake (D) to the rolling
cabinet (C) using four bolts (CC) and washers (BB) per
caster. The s wivel casters with brake (D) should be
installed on the same side as the side handle (B) .
□ Mount the two rigid casters (G) to the rolling
cabinet (C) using four bolts (CC) and washers (BB) per
caster.
□ Tighten all bolts with a 13 mm wrench (DD).
□ Return the rolling cabinet (C) to its upright position.
BB
DD
CC
4
Attaching the safety brackets (optional)
NOTE: This step is optional. User can decide whether
to attach the brackets or not.
□
Attach the safety brackets (K) to the cabinet by using two bolts
(AA) and two screws (FF) for the other side on the wall.
□
Tighten all bolts using a screwdriver and a wrench.
Do not over tighten the bolts to avoid damage to the finish.
6 6
on top of the
B
C
D
G
□
FF
K
AA