Advertisement
Large Floor Nozzle
Small Nozzle
l
Long Nozzle
l
2.2.
Specification
l
Motor . . . .230V 1100W
2.3.
Assembly
2.3.1. Push fit castors into the holes in the underside of the base.
2.3.2. Remove the motor head as in para.2.1.2.
2.3.3. Fit the cloth filter (A) first and then the paper filter bag (B) and retain both with the elastic
band, see fig. 1.
2.3.4. Replace motor head, noting the alignment guide, and raise the handle to lock.
2.3.5
Attach cable clips (for cable stowage) to handle by clipping them into the slots provided in
central web of handle.
2.3.6. Connect flexible hose to tank and fit extension tubes and nozzle to suit task.
The cleaner is now ready for dry vacuum cleaning.
Note: The cloth filter is reusable but the paper filter bags are not.
IMPORTANT! You must change the paper filter bag regularly. If the machine is used without the
special bag the motor will eventually burn out and your guarantee will be invalidated. Always
keep a pack of spare bags handy.
Paper Filter Bags
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Part No. VAC/05 (pack of 10)
Cartridge Filter (Optional) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Part No. VAC/02/DL (replaces cloth and paper filters for dry vacuuming)
3. WET VACUUM CLEANING
p WARNING! Ensure you read, understand and apply Section 1 “Safety Instructions”.
Reminder: Remove plug from power supply before opening unit.
DO NOT v a c u u m s o l v e n t s , e x p l o s i v e s , i n f l a m m a b l e a n d / o r hazardous
liquids such as petrol, oil, spirits, paint, thinners, acids etc.
3.1.
Ensure the machine is unplugged from the power supply.
3.2.
Make sure the tank is clean and free from dust and dirt.
3.3.
Remove the paper filter bag but leave the cloth bag retained by the elastic band.
3.4.
Fit the long nozzle to the same flexible hose as used in dry cleaning.
3.5.
Ensure the switch is in the “Off” position and then plug the cleaner into the power supply.
3.6.
To vacuum large quantities of liquid, from a sink, or tank, etc., do not immerse nozzle completely
in the liquid, leave a gap at the top of the nozzle opening to allow an air inflow. See fig. 2.
3.7.
The machine is fitted with a float valve which stops the suction action when the tank has reached
its maximum capacity or if the cleaner is overturned. There will be an increase in motor speed.
When this happens, turn off cleaner, disconnect from power supply, remove head from tank
and empty liquid into a suitable receptacle or drain. To continue vacuuming, refit head and proceed.
3.8.
After wet vacuuming, turn off the cleaner and disconnect from the power supply.
3.9.
Empty the tank and clean and dry the inside and outside before storage.
Remember! After wet vacuuming a paper filter bag must be fitted before dry vacuuming again.
4.
TROUBLESHOOTING
Cleaner will not operate.
Dust comes from the motor cover.
Reduced efficiency and increased
motor speed/vibration.
5.
DECLARATION OF CONFORMITY
Declaration of Conformity We, the sole importer into the UK of Sealey Power Products, declare that the product listed below is in conformity
with the following standards and directives.
Wet & Dry Vacuum Cleaner
Model: PC118
73/23/EEC Low Voltage Directive
89/336/EEC EMC Directive
93/68/EEC Marking Directive
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No responsibility is accepted for incorrect use of this equipment. WARRANTY: Guarantee is 12 months from purchase, proof of
which will be required for any claim. INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full
name and address, including postcode.
01284 757500
Bristle Attachment
Extension Tube (2)
l
Flexible Hose
l
l
Air Flow . . . .210m 3 /h
Tank . . .15ltr
No power supply.
Faulty power cable, switch or motor.
Container full of liquid.
Paper filter bag missing or damaged.
Paper filter bag and/or cloth filter clogged.
Nozzle, hose or tank inlet blocked.
Sole U.K. Distributor, Sealey Group,
Bury St. Edmunds, Suffolk.
01284 703534
Castor (4)
Paper Filter Bag (3)
l
Cloth Filter
l
l
Weight . . . .6kg
Check supply.
Check and repair or replace faulty item.
Empty container.
Fit or replace.
Replace paper filter bag and/or clean cloth filter.
Check nozzle, hose and tank inlet for blockage.
The construction file for this product is held by the Manufacturer and may
be inspected, by a national authority, upon request to Jack Sealey Ltd.
Signed by Mark Sweetman
For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Products.
E-mail: sales@sealey.co.uk
Elastic Band
Cable Clips
l
l
fig. 1
fig. 2
18th April 2001
PC118 - 1007 - (1) - 180401
Advertisement
