Sealey PC102 Instructions

thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instruction
manual
1. SaFety
1.1.

electrical SaFety

warninG! it is the user's responsibility to check the following:
‰
check all electrical equipment and appliances to ensure that they are safe before using. inspect power supply leads, plugs and all
electrical connections for wear and damage. sealey recommend that an rcd (residual current device) is used with all electrical
products. You may obtain an rcd by contacting your local sealey stockist.
if the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAt (Portable Appliance
test) tested.
electrical safety information: it is important that the following information is read and understood.
1.1.1. ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
1.1.2. regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
1.1.3. important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the correct
fuse - see fuse rating in these instructions.
dO nOt pull or carry the appliance by the power cable.
8
dO nOt pull the plug from the socket by the cable.
8
dO nOt use worn or damaged cables, plugs or connectors. ensure that any faulty item is repaired or
8
replaced immediately by a qualified electrician.
1.1.4. This product is fitted with a BS1363/A 13 Amp 3 pin plug.
if the cable or plug is damaged during use, switch the electricity supply and remove from use.
Ensure that repairs are carried out by a qualified electrician.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.
A) Connect the BROWN live wire to the live terminal 'L'.
B) Connect the BLUE neutral wire to the neutral terminal 'N'.
c) After wiring, check that there are no bare wires and ensure that all wires have been correctly connected.
dO nOt connect either wire to the earth terminal.
ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
class ii products are wired with live (brown) and neutral (blue) only and are marked with the class ii symbol;
Sealey recommend that repairs are carried out by a qualified electrician.
if an extension reel is used it should be fully unwound before connection. A reel with an rcd fitted is
preferred since any appliance plugged into it will be protected. the cable core section is important and should be at least 1.5mm², but to
be absolutely sure that the capacity of the reel is suitable for this product and for others which may be used in the other output sockets,
we recommend the use of 2.5mm² section cable. if extension reel is to be used outdoors, ensure it is marked for outdoor use.
1.2.

General SaFety

disconnect the cleaner from the power supply before servicing, changing accessories, or performing any maintenance.
9
use only genuine parts and accessories. unauthorised parts and accessories may be dangerous and will invalidate your warranty.
9
maintain the cleaner in good condition. use an authorised agent for servicing. Keep machine clean, but dO nOt use solvents.
9
for dry vacuuming ensure the filter is firmly in place before operating the cleaner.
9
dO nOt operate the unit without the cloth filter in place. Using the cleaner without the cloth filter may cause damage to the
8
vacuum cleaner and will invalidate your warranty.
dO nOt allow children or untrained persons to operate the cleaner.
8
dO nOt place attachments close to your face (especially eyes, ears, etc). dO nOt point the hose end at other persons or animals.
8
▲ danGer! dO nOt vacuum hot or glowing ash, cigarette ends, inflammable, explosive, corrosive or other dangerous substances.
dO nOt leave machine running unattended. turn power supply off, and dO nOt leave the vicinity until motor has come to a complete stop.
8
dO nOt operate the cleaner while under the influence of drugs, alcohol or impairing medication, or if you are tired.
8
dO nOt use the cleaner in the rain or in very damp conditions.
8
dO nOt use the cleaner for a task it is not designed to perform.
8
When not in use, store the cleaner in a safe, dry, childproof location.
9
2. intrOductiOn
i
High powered, lightweight Wet and Dry unit with blower facility and has 10 litre capacity. Constructed from high impact composite material with tool
and hose storage points on head. four castors to aid manoeuvrability. ideal for vehicle, home and general workshop use. supplied with crevice and
floor tools, washable cloth filter, 3.5 mtr. cable and 3 pin plug.
© Jack sealey limited
instructions for
vacuum cleaner wet & dry 10ltr.
Pc102, Pc102Hv
model no:
Original Language Version
recommended fuse rating:
13 amP
PC102, PC102HV Issue 1 12/12/17