Sealey POWERCLEAN COMBI PC118 Instructions

Thank you for purchasing an Sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND
CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY
CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.1. ELECTRICAL SAFETY. p WARNING! It is the user’s responsibility to read, understand and comply with the following:
You must check all electrical equipment and appliances to ensure they are safe before using. You must inspect power supply leads, plugs and
all electrical connections for wear and damage. You must ensure the risk of electric shock is minimised by the installation of appropriate safety
devices. An RCCB (Residual Current Circuit Breaker) should be incorporated in the main distribution board. We also recommend that an RCD
(Residual Current Device) is used with all electrical products. It is particularly important to use an RCD with portable products that are plugged
into an electrical supply not protected by an RCCB. If in doubt consult a qualified electrician. You may obtain a Residual Current Device by
contacting your Sealey dealer. You must also read and understand the following instructions concerning electrical safety.
1.1.1. The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by
a qualified electrician, using a Portable Appliance Tester (PAT), at least once a year.
1.1.2. The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance
and the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.
1.1.3. Ensure the insulation on all cables and the product itself is safe before connecting to the mains power
supply. See 1.1.1. & 1.1.2. above and use a Portable Appliance Tester (PAT).
1.1.4. Ensure that cables are always protected against short circuit and overload.
1.1.5. Regularly inspect power supply, leads, plugs for wear and damage and all electrical connections
to ensure that none is loose.
1.1.6. Important: Ensure the voltage marked on the product is the same as the electrical power supply
to be used.
1.1.7. DO NOT pull or carry the powered appliance by its power supply lead.
1.1.8. DO NOT pull power plug from socket by the power cable.
1.1.9. DO NOT use worn or damage leads, plugs or connections. Immediately replace or have repaired by
a qualified electrician. A U.K. 3 pin plug with ASTA/BS approval is fitted. In case of damage, cut off
and fit a new plug according to the following instructions (discard old plug safely).
(UK only - see diagram at right). Ensure the unit is correctly earthed via a three-pin plug.
a) Connect the GREEN/YELLOW earth wire to the earth terminal ‘E’.
b) Connect the BROWN live wire to live terminal ‘L’.
c) Connect the BLUE neutral wire to the neutral terminal ‘N’.
d) After wiring, check that there are no bare wires, that all wires have been correctly connected, that the external insulation
extends beyond the cable restraint and that the restraint is tight.
Double insulated products are fitted with live (BROWN) and neutral (BLUE) wires only. Double insulated products are always marked with
this symbol . To re-wire, connect the brown & blue wires as indicated above. DO NOT connect the brown or blue to the earth terminal.
1.1.10. Cable extension reels. When a cable extension reel is used it should be fully unwound before connection. A cable reel with an RCD
fitted is recommended, since any product which is plugged into the cable reel will be protected. The section of the cable cores is
important and should be at least 1.5mm
others that may be used in the other output sockets, we recommend the use of 2.5mm
1.2 GENERAL SAFETY
Disconnect the cleaner from the power supply before servicing, changing accessories, or performing any maintenance.
Use only genuine parts and accessories. Unauthorised parts and accessories may be dangerous and will invalidate your warranty.
3
Maintain the cleaner in good condition. Use autho r i s e d a g e n t for servicing. Keep machine clean, but DO NOT use solvents.
3
Ensure the correct Sealey paper filter bag is firmly in place before operating the cleaner. Incorrect bags may cause machine faults and
3
will invalidate your warranty.
3
Wear protective clothing and gloves.
DO NOT allow children or untrained persons to operate the cleaner.
3
DO NOT place attachments close to your face (especially eyes and ears). Do not point the hose end at other persons or animals.
7
DANGER! DO NOT vacuum very fine powders, hot or glowing ash, inflammable, explosive, corrosive or other dangerous substances.
7
DO NOT operate the unit without the paper filter bag (except when wet vacuuming or when the optional cartridge filter is fitted).
s
DO NOT leave machine running unattended. Turn power supply OFF, and DO NOT leave the vicinity until motor has come to a complete stop.
7
DO NOT operate the cleaner while under the influence of drugs, alcohol or impairing medication, or if you are tired.
7
DO NOT use the cleaner in the rain or in very damp conditions.
7
DO NOT use the cleaner for a task it is not designed to perform.
7
When not in use, store the cleaner in a safe, dry, childproof location.
7
3
2. CONTENTS, SPECIFICATION & ASSEMBLY
2.1. Carton content
2.1.1. Carefully unpack the carton.
2.1.2. Move the cleaner handle to the horizontal position, lift off the motor head and take out the items in the tank.
2.1.3. Check and identify each accessory as listed over. If anything is missing or damaged please contact your supplier immediately.
POWERCLEAN COMBI
INSTRUCTIONS FOR:
WET & DRY VACUUM CLEANER
PC118
Model:
, but to be absolutely sure that the capacity of the cable reel is suitable for this product and for
2
Yellow & Green
Earth Wire
Blue
Neutral
Wire
FUSE RATING
10 AMP
section cable.
2
PC118 - 1007 - (1) - 180401
Brown
Live
Wire
Cable
Restraint