Cisco UC500 Series Technical Training Manual page 20

o For IP Phone with x202
i. Select the Paging Group 1 from the pull down
ii. Select the Pickup Group 1 from the pull down
iii. Set Permissions to National. Make sure "Block restricted number" is checked
iv. Verify that the Intercom to aip is configured on button 2.
v. Make sure the DID number configured previously shows up – then click OK
o For the CIPC phone with x203
i. Select the Pickup Group 1 from the pull down
ii. Set Permissions to National. Do not check "Block restricted number"
iii. Make sure no PSTN number shows – then click OK
19. Click on "OK" button at the bottom of the screen and observe the progress bar. Click OK when
the "Configuration successfully sent to UC520" message pops up. It may take several minutes
for the configuration to be fully applied.
20. Configure a system-wide speed dial. Click on 'Configure -> Telephony -> System Speed Dial'
Click the "Add" button and configure a name and a corresponding number (eg. "Cisco Support",
Number: 918005532447). Remember to include the PBX Access code and the long distance prefix
for the speed-dial. These parameters are defaulted to 9 and 1 respectively for North American dialing
and can be changed in the "Dial Plan" tab. Click OK to apply the configuration.
Cisco Unified Communications Technical Training
LAB 2: PBX, Voicemail & DialPlan
Page 20 of 171