IBM Power System 8248-L4T Manual page 17

13. Place the system into the operating position. For instructions, see Placing the rack-mounted
8248-L4T, 8408-E8D, or 9109-RMD system into the operating position.
14. Replace the front cover. For instructions, see Installing the front cover on the 8248-L4T, 8408-E8D, or
9109-RMD.
15. Reconnect all power and signal cables to their respective connectors.
16. Close the rear rack door or the rear system door.
17. Start the system. For instructions, see Starting the system or logical partition.
18. Verify the installed part:
v If you replaced the part because of a failure, verify the installed part as described in Verifying a
repair.
v If you installed the part for any other reason, verify the installed part as described in Verifying the
installed part.
Removing the 8248-L4T, 8408-E8D, or 9109-RMD processor voltage
regulator module
Use this procedure to remove a processor voltage regulator module.
Attention: If you are removing a voltage regulator module to install a new or upgraded voltage
regulator module, see "Installing the 8248-L4T, 8408-E8D, or 9109-RMD processor voltage regulator
module" on page 2. If you are removing a voltage regulator module as part of a service procedure,
continue to use the following procedure.
If your system is managed by the Hardware Management Console (HMC), use the HMC to remove a
processor voltage regulator module from the server. For instructions, see Removing a part by using the
Hardware Management Console.
If you do not have an HMC, complete the following steps to remove a processor voltage regulator
module:
Voltage regulator modules
5