Graco Ultra Operation, Parts page 7

10. Turn Prime Pump/Spray knob forward to
SPRAY position.
11. While holding the sprayer upside down
point the sprayer into a waste pail.
a. With the spray tip in the SPRAY
position, pull the trigger for five
seconds. Release the trigger.
ti30231a
b. Reverse the spray tip to UNCLOG
position, pull the trigger for five
seconds. Release the trigger.
ti30232a
3A4476B
12. If second spray tip was used, remove
cleaned spray tip from spray tip guard
and install second spray tip. See Spray
Tip Installation, page 22. Repeat steps
10 and 11 to clean second spray tip.
ti29768a
13. Remove cup assembly and discard used
fluid. Dispose of used cleaning fluid
properly.
14. Replace cleaning fluid and repeat steps
5 – 13 until spray output is clean.
IMPORTANT! For best results, do not spray
more than one cup of water through the tip
while cleaning. If more flushing is needed,
remove the tip from the sprayer to avoid
excessive wear.
Cleanup
19