Assembling The Blower; Removing And Fitting The Battery - Stihl BGA 300.0 Instruction Manual

English
► Check the controls,
► If it is not possible to carry out these steps: Do
not use the blower and consult a STIHL
authorized dealer.
6

Assembling the Blower

6.1 Attaching the Blower Tube
1
2
3
► Push "clamp with wiring harness retainer" (2)
onto the elbow (1).
► Push the pleated hose (3) onto the elbow (1).
The pleated hose (3) fits flush with the
elbow (1).
► Push the "clamp with wiring harness
retainer" (2) onto the pleated hose (3) up to
the limit stop and align it so that the screw
eye (5) points downward.
► Insert the screw (4) and secure it firmly.
3
6
7
► Push clamp (6) onto the blower tube (7).
► Push the blower tube (7) into the corrugated
hose (3) as far as it will go.
► Align the blower tube (7) so that the handle
(10) points upwards.
► Push the clamp (6) onto the pleated hose (3)
as far as it will go and align it so that the screw
eye (9) points downwards.
► Insert and firmly tighten the screw (8).
22
10.
4
5
10
8
9
11
12
► Press socket (11) into the wiring harness
retainer (12).
The socket engages with an audible click.
6.2 Attaching and Removing the
Nozzle
► Shut off the engine.
► Line up the pin (3) and hole (4).
► Push nozzle (1) onto the blower tube (2).
► Turn the nozzle (1) until it engages.
The nozzle does not need to be removed again.
7 Removing and Fitting the
Battery
7.1 Inserting the Battery
1
► Place the battery (1) on the back plate (2) so
that the guides on the back plate (2) fit into the
recesses on the battery (1).
6 Assembling the Blower
2
3
4
2
0458-724-9601-A
1