Nedis RFPS110WT, RFPSD110WT - RF Smart Build-In Switch Quick Start Guide

Intended use

The Nedis RFPS110WT | RFPSD110WT is a build-in adapter that allows you to control a connected device or light source.

Pair it with a Nedis RF Wall Switch or Nedis RF Smart Remote Control for wireless use (sold separately).

The product is intended for indoor, domestic use only.

Any modification of the product may have consequences for safety, warranty and proper functioning.

Main parts

(image A)

1. Status indicator LED
2. Power and reset button
3. Wire terminal (neutral)
4. Wire terminal (in)
5. Wire terminal (out)
6. Mounting wings

Safety instructions

• Only use the product as described in this manual.
• Risk of electric shock. The product should only be opened by an authorized technician when service is required.
• Disconnect the product from the power outlet if a problem occurs.
• Do not use the product if a part is damaged or defective. Replace a damaged or defective device immediately.
• Read the manual carefully before use. Keep the manual for future reference.
• Do not stack the product.
• Do not drop the product and avoid bumping.
• Do not use the product in wet or damp environments.
• Do not expose the product to water or moisture.

Installing the product

Keep a distance of at least 1 m between your Nedis RF Smart products.

1. Insert the mains phase wire into the wire terminal A.
2. Insert the switch wire from a device into A.
3. Insert the neutral wire into A.
4. Tighten the screws.
5. Place the product in a junction box.
   Make sure the power and reset button Ais accessible.
6. Insert screws through the mounting wings A to fasten the product.
7. Press the power and reset button Ato switch the device on or off.

Setting the product to pairing mode

You can pair the product with a Nedis RF Wall Switch or Nedis RF Remote Control for wireless use (sold separately).

The product must be paired with a Nedis RF transmitter to access the dim function (RFPSD110WT only).

1. Hold the transmitter close to the product.
2. Press and hold Auntil the status indicator LED Aflashes. The product is now in pairing mode.
3. On the transmitter, press an ON button to connect to the product.

The product makes a clicking sound when successfully paired to a Nedis RF transmitter.

For more options:

• Follow the instructions in the manual of the Nedis RF transmitter.

Specifications

Declaration of Conformity

We, Nedis B.V. declare as manufacturer that the product RFPS110WT | RFPSD110WT from our brand Nedis^®, produced in China, has been tested according to all relevant CE standards and regulations and that all tests have been passed successfully. This includes, but is not limited to the RED 2014/53/EU regulation.

The complete Declaration of Conformity (and the safety datasheet if applicable) can be found and downloaded via: webshop.nedis.com/rfps110wt#support webshop.nedis.com/rfpsd110wt#support

For additional information regarding the compliance, contact the customer service:
Web: www.nedis.com
E-mail: service@nedis.com
Phone: +31 (0)73-5991055 (during office hours)

ned.is/rfpsd110wt

ned.is/rfps110wt

Nedis BV
De Tweeling 28, 5215 MC 's-Hertogenbosch
The Netherlands