Setup Troubleshooting; Additional Information - IBM eserver Cluster 1350 Installation And Service Manual

Go to: http://www.cisco.com/warp/public/707/cisco-malformed-snmp-msgs-pub.shtml
for specific firmware patches to download.

Setup troubleshooting

Once the initial setup is complete, there should be a network connection between
the PC and the switch. If a ping to the switch fails, make sure that the IP address
and gateway to make sure the subnet and gateway addresses match:
v On the PC, at the command prompt, type: ipconfig
v On the switch, at the command prompt, type: show running
Nodes on the same VLAN can communicate via ping and telnet. They cannot
communicate to nodes on different VLANs. To Make sure thatMake sure that
VLANs:
v Connect node1 and node2 to the same VLAN and ping node2 from node1. This
ping should succeed.
v Connect node1 to VLAN1 and node2 to VLAN2 and ping node2 from node1.
This ping should fail.

Additional information

Catalyst 5000 Family Ethernet and Fast Ethernet Switching Modules Installation and
Configuration Note (including Translated Safety warnings 10 languages):
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/cnfg_nts/ethernet/5014etsm.htm#20508
Catalyst 3500 Series XL Hardware Installation Guide Includes Troubleshooting:
http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35wc/3500ig/index.htm
Catalyst 2900 Series XL and 3500 Series XL Cisco IOS Release 12.0(5.3)XU:
http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35wc/rn53/1061505.htm
Quick Start Guide Catalyst 3500 Series XL Switches:
http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35xu/3500.htm
64 IBM Eserver Cluster 1350 Installation and Service Guide