To Tie On Mantles - Coleman NorthStar 2500B Instructions For Use Manual

To Tie On Mantles

WARNING
•
Replace any mantle with a hole in it. A hole can cause lantern to overheat
and create a hazard. Never operate lantern without heat shield.
Always use genuine Coleman
Mantles.
Attach MANTLE to BURNER
TUBE AND LOWER MANTLE
SUPPORT. Keep red stripe vertical
and be sure clips engage grooves.
Twist clips.
6
®
Lower
Mantle
Support
Burner
Tube
Light mantle evenly and leave to
burn. Once mantle has been burned
it is very fragile. Be careful not to
touch it with your finger or match.
Twist clips.
Replace VENTILATOR and
GUARD/GLOBE ASSEMBLY. Position
guard wire into notch in frame.
NOTE: When re-installing globe onto
lantern be sure not to contact mantle
clip. Mantle may be dislodged from
groove.