Initial Setup Using Web Management - SonicWALL CSa 1000 Getting Started Manual

Initial Setup Using Web Management

This section describes how to configure network settings on your Capture Security Appliance, including time zone
and mail server settings.
If you haven't already changed the password for the administrator account, SonicWall strongly recommends that
you do that right away. (Refer to
To perform initial CSa setup using the web management interface:
1. Point your browser to https://192.168.168.168, the default LAN (X0) IP address.
2. Log into the CSa using the admin account credentials (default: admin/password).
3. Navigate to the Configuration > Network page.
4. Configure the following settings on the Network screen:
In the MANAGEMENT (X0) section, optionally change the IP address of the X0 interface. Set the
l
IPv4 field to an address on your local management subnet. The default is 192.168.168.168.
Change the Netmask field as needed for your subnet. The default is 255.255.255.0.
Change the Administrator Password
Capture Security Appliance 1000 Getting Started Guide
for instructions.)
Initial Setup Using Web Management
9
15