NEC NP41 User Manual page 54

Selectng Aspect Rato [ASPECT RATIO]
Aspect Ratio allows you to select the best Aspect mode to display your source image.
You can also display the Aspect Ratio window by pressing the ASPECT button on the remote control. (→ page 7)
NORMAL
WIDE ZOOM
CINEMA
NATIVE
(RGB only)
NOTE: When you are displaying an RGB image with a higher resolution than the projector's native resolution such as SXGA, the
image will be displayed in the projector's native resolution (XGA) even if [NATIVE] is selected.
NOTE: Please note that using this projector for the purpose of commercial gain or the attraction of public attention in a venue
such as a coffee shop or hotel and employing compression or expansion of the screen image with a [ASPECT RATIO] setting
may raise concern about the infringement of copyrights which are protected by copyright law.
Standard 4:3 aspect
The 16:9 image is stretched left and right to fit 4:3 screen. Some left and right edges of
the image are cut out.
16:9 signal
The 16:9 image is compressed top and bottom of the image to fit 16:9 screen. You can
adjust the image position for [CINEMA] aspect. See [CINEAMA POSITION] for setting
the image position. (→ page 46)
16:9 signal
The projector displays the current image in its true resolution. Selecting other options
than [NATIVE] will expand or reduce the image to fit the projector's native resolution (1024
x 768 pixels).
Example: When a source with 800 x 600 pixels is selected:
[NATIVE]
1024
800
768
600
NOTE: When a non- RGB is selected, you cannot select [NATIVE].
Opton other than
[NATIVE]
1024
768

. Usng On-Screen Menu