NEC NP41 User Manual page 28

Selectng Default Source
You can set a source as the default source so that the default source will be displayed each time the projector is
turned on.
1. Press the MenU button.
The menu will be displayed.
2. Press the seleCt ▶ button twice to select [setUP]
and press the seleCt ▼ button or the enter button
to select [general].
3. Press the seleCt ▶ button three times to select [OP-
tiOns(2)].
4. Press the seleCt ▼ button six times to select [de-
faUlt sOUrCe seleCt] and press the enter button.
The [DEFAULT SOURCE SELECT] screen will be dis-
played.
(→ page 54)
5. select a source as the default source, and press the
enter button.
6. Press the eXit button a few times to close the menu.
7. restart the projector.
The source you selected in step 2 will be displayed.
TIP: When the projector is in Standby mode, applying an RGB signal
from a computer connected to the COMPUTER IN input will power
on the projector and simultaneously project the computer's image.
([AUTO POWER ON(COMP.)] → page 54)
3. Projectng an Image (Basc Operaton)
9