Coleman MONTANA 14'x7' Installation Manual

When You Are Ready
To Set Up Your Tent
– Select a level campsite clear of
rocks, branches and other hard or
sharp objects.
– Do not set up your tent under trees.
– For best results in windy conditions,
position the end of tent into the wind.
1 Layout & Positioning
of Tent, Pole Assembly
– Layout and position tent with door
facing desired direction. (illus. 1)
– Unzip door.
– Stake down tent corners, using the
tent stake loops. Keep the floor taut.
(illus. 2)
– Assemble all poles by interlocking
shock-corded poles.
– Insert the black poles into center pole
sleeves. The poles should cross
forming an "X" in the middle of tent.
(illus. 1)
Front door
MONTANA
Instructions apply to Part Number 2000000139
(2) Main Tent Poles
(2) Side Tent Poles
(2) Rainfly Poles Part No. 9279B3481
Black poles
illus. 1
illus. 2
Tent
stake through
stake loop
POLE ASSEMBLY PARTS
Part No. 9279B3451
(Black)
Part No. 9279B3461
(Grey)
2 Connect Frame to Tent
– Locate the pin & ring systems on
either side of the front door and the
corresponding pin & rings on the back
side of tent.
– Insert one end of black frame pole
onto pin & ring system on tent stake
loop on either side of front door. (illus. 3)
– Go to opposite end of pole diagonally
from starting point and gradually apply
pressure to the pole forming an arch
until you are able to insert the pin into
pole end.
– Repeat for second pole.
– Attach tent frame clips to poles.
14'x7'
™
illus. 4
Center section upright
illus. 3
Pin & ring system located
on the front & rear of tent
Rainfly Part No.
9279B3491
Black poles