Accessories; Electric Outlet (12 Volt), Plug, Smartphone Holder, Cup Holder And Utility Box; Transporting The Machine; Hydrostatic Transaxle Bypass Rods - Kubota Z411-AU Operator's Manual

ACCESSORIES

• Apply the parking brake.
• Lower all implements to the ground.
• Shut off the engine.
• Remove the key.
• Place the motion
"NEUTRAL LOCK" position.
To lock:
1. Depress the parking brake pedal firmly with the left
side of your right foot.
2. While keeping the parking brake pedal depressed,
use the right side of your right foot to depress the
parking brake lock pedal.
3. Release the parking brake pedal while holding the
parking brake lock pedal down.
4. Release the parking brake lock pedal.
To unlock:
Depress the parking brake pedal and release it slowly
with your right foot without pressing the parking brake
lock pedal.
If necessary to park on an incline, be sure to chock the
wheels on the downhill side to prevent accidental rolling
of the machine.
(1) Chock
ACCESSORIES
1. Electric outlet (12 volt), plug,
smartphone holder, cup holder and
utility box
• A 12 volt outlet is on the left-hand fender. An
electrical charger or other device may be connected
to this outlet.
• A 12 volt plug is behind the seat in the blue tape.
An auxiliary light or other device may be connected
to this plug.
• The outlet and plug are only powered when the key
switch is at the "ON" or "START" position.
• Do not connect lights or other devices that draw
more than a total of 84 watts to these power points,
Z411-AU, Z421-AU
control levers in the
or the battery may discharge very rapidly, or the
outlet or plug may fail.
IMPORTANT :
• Do not use the outlet as a cigarette lighter.
• Do not use the outlet or the plug when it is wet.
• Make sure that the outlet cap is closed when the
outlet is not used.
(1) 12 volt outlet
(2) Smartphone holder
(3) Cup holder

TRANSPORTING THE MACHINE

• To transport the machine on a trailer:
– Turn the fuel valve to the "OFF" position.
– Fasten the machine to the trailer.
• Do not attempt to tow this machine, or damage to
the transmission may result.
• When trailering the machine over a long distance:
– Make sure to lower the mower to the 38.1 mm
(1.5 in.) cutting height by using the mower lift
pedal.
• When transporting the machine under its own
power:
– Make sure to lift the mower to the top position
by using the mower lift pedal.

1. Hydrostatic transaxle bypass rods

DANGER
To avoid serious injury or death:
• Do not use bypass levers on or around slopes.
The machine can run away and cause injury or
death easily.
WARNING
To avoid serious injury or death:
• Do not touch the muffler or exhaust pipes while
they are hot. Severe burns could result.
OPERATING THE MACHINE
(4) Utility box
(5) 12 volt plug
39