Advertisement
protection cover in order to protect the sensor from direct
rainfall. The operating temperature of the product is between -
20 to + 50ºC. If the reader is installed in an environment where
the temperature can drop below -10ºC or/and if the sensor
could only be exposed to direct sunlight, it is strongly
recommended to install the reader inside a third party sealed
wall mount box (fitted with additional heater if very low
temperature) to keep a constant sensor level performance. We
cannot guarantee the functionality of the product if the
recommendations and advice are not followed.
Specifications
Fingerprint Capacity:
97 templates
PIN Code Capacity:
97 PIN Codes (1 to 8 digits)
Output:
1 x Relay (2A at 24V AC/DC)
Push Button Input:
Yes
Door Open Time:
Pulse (1 to 30 seconds) or Toggle (ON/OFF)
Entry Mode:
Finger or access code
Programming:
By swiping or by keypad
Master/Admin Fingers: 1 Administrator and 1 Installer finger
Backlight ON/OFF:
Yes
Buzzer ON/OFF:
Yes
Firmware upgrade:
via RS485 converter and windows application
Current Consumption:
150 mA max.
Power Supply:
9 to 14 V DC
Indication:
Tricolor Status LED
IP Factor:
IP65
Storage/Operating
-20 to +50°C
Temperature :
Storage/Operating
5% to 93% noncondensing
Humidity:
Dimensions
100 x 94 x 30 mm
Application diagram
Figure 2: Application diagram
ACL800FL-RU2
ACL870FL-PB
ACL870SU-PB
Secured Area
ACL800FL-RU2 : Optional) 2 Relay Remote Unit
ACL870FL-PB (Optional): 2 Relay Remote Unit and request-to-
exit Button
ACL870SU-PB (Optional) : 1 Relay Remote Unit and request-
to-exit Button
2 / 7
ACL875SU-BS
Outside
Wiring
Figure 3: Wiring
Red
12 VDC
Black
GND
Pink
A
Violet
B
Blue
Tamp
Green
Tamp
Orange
PB
Push Button
Gray
NC
Yellow
COM
white
NO
Figure 4: Wiring ACL870SU-BSMF with magnetic lock
Recommended swiping technique
Figure 5: Swiping technique
Follow the below instructions for correct finger swiping. Starting
from the first finger joint, place the selected finger on the swipe
sensor and move it evenly downwards in one steady
movement.
Result:
For a valid swipe: Tricolour status LED turns green + OK beep
(short + long beep)
P/N 1073523A• REV 00.00 • ISS 4JUL18
Red
Black
Pink
Violet
Blue
Green
Orange
Gray
Yellow
White
+12 VDC
Ground
A (RS485)
B (RS485)
Tamper
Tamper
NC
COM
NO
12 VDC
POWER
SUPPLY
Advertisement
