Table of Contents
Advertisement
Troubleshooting
Problem
Switch "Size" in "HDMI Setting" to "1" or "2" (for 480p (525p)
signals only).
Read the user manual of the connected device and perform
Wrong screen size
the following:
- Check if the output settings of the device are appropriate.
- Change the signal formats of the device to others.
No picture, no sound
Use the cable marked with HDMI logo.
Check if the device is compliant with HDMI.
Switch "Audio" in "HDMI Setting" to "Digital" or "Auto" for
No sound
HDMI devices, or "Analogue" or "Auto" for DVI devices.
(Not available for "EXT-6".)
Green and distorted
Wait a little for the signal to stabilize when switching the
screen
signal format for an "HDMI" device.
Is the T-V LINK compatible device connected to EXT-2?
Is the SCART cable "Fully Wired"?
Is the T-V LINK compatible device turned on?
"Feature Not Available"
After confirming all the conditions above,
press "OK" button again.
Press 2 to start ACI again.
"ACI Error"
If you still receive the "ACI Error" after numerous tries,
press 3 to cancel ACI.
"No Recording"
A problem occurs at the recorder.
" No Recording
The displayed video cannot be recorded.
Possible"
" No Recording Media
The recorder is not ready for recording.
Problem"
Check the video tape or DVD disc.
" No Recording Device
The recorder is recording another programme, or is playing.
Busy"
(continued)
Actions
page
22
–
–
–
22
–
33
–
–
–
–
–
–
–
Problem
Unnatural colour >>> Adjust "Colour" and "Bright".
Noise >>> Set to the following functions.
Picture Mode :
Poor picture quality
Super DigiPure : Max
Dull picture >>> Set to the following functions.
Picture Mode :
Super DigiPure : Min
If you connected S-Video output device, check the "S-IN"
setting.
If the top of the image is distorted, check the video signal
Strange picture
quality itself.
when using an external
If movement appears unnatural when receiving a signal from
device
a DVD player, etc. with 625p (progressive scanning), change
the output setting of the external device to 625i (interlaced
scanning).
Blue screen appears
Switch "Blue Back" to "Off."
on the screen
Keep the TV off for a while and then turn the power on again.
If the TV goes into warning mode, unplug the TV after the
The LAMP indicator
cooling has completed and consult your retailer. (It may be a
blinks rapidly
malfunction of the internal electrical circuits.)
Keep the TV off for a while and then turn the power on again.
The power lamp and
If the TV goes into warning mode, unplug the TV after the
LAMP indicator blink
cooling has completed and consult your retailer. (The inside
alternately
temperature rises abnormally or the fan may be blocked.)
If this condition occurs soon after replacing the lamp, reinstall
the new lamp unit. (The lamp unit may not be inserted into the
lamp housing correctly.)
Repeat the lamp installation steps, taking care to observe all
warnings.
The power lamp and
- Make sure the lamp sits flat inside the housing area.
LAMP indicator blink
- Make sure the lamp cover is reinstalled.
rapidly simultaneously
If this condition occurs except for replacing the lamp, keep
the TV off for a while and then turn the power on again. If the
TV goes into warning mode, unplug the TV after the cooling
has completed and consult your retailer. (It may be a lamp
malfunction.)
Actions
page
22
24
Check your "Colour System".
22
Standard
24
22
Bright
24
17
–
–
22
–
–
4
–
31
Advertisement
Table of Contents
