JVC HD-58DL8U Instructions Manual page 15

Initial settings
Confirm the language
3
Language for on-screen analogue
> Language
channel displays and menus
(excluding the DTV menu)
When not using analogue channels
When using analogue channels (or cable TV)
4 Set analogue channels
1
Register analogue channels
> Auto Program
Country
United Kingdom Ireland
Deutschland Switzerland
France Danmark
Italia Sverige
España Österreich
Nederland Norge
Belgium Suomi
>> Auto Program
0%
2
Check what was registered
> Edit
PR ID CH/CC
AV
------
01 YLE1 CH 02
02 CH 03
03 CH 04
04 CH 05
05 CH 06
06 CC 01
07 CC 02
08 CC 03
09 CC 04
3
Set TV-LINK
T-V LINK
Download TV Recording Device
Initial setting is complete
5
Edit digital channels "Editing digital channels" (P. 28)
If digital channel reception is poor
When the digital channel reception is poor (right column)
If analogue channel reception is poor
Some digital channels cannot be watched on this TV.
"Digital channels that cannot be watched on this TV" (P. 33)
(continued)
When changing a language
select
@
⁄
When changing a country
select
If "ACI Start" appears, select and start settings.
(This will set up cable television channels.)
CH 02
"What is "ACI" (Automatic Channel
Installation)?" (P. 33)
Edit analogue channels Confirm
in "Editing analogue
@
channels" (P. 29)
When not using
When using T-V LINK
T-V LINK
If "Feature Not Available"
appears :
Is a T-V LINK compatible
device connected to EXT-2?
Is the device turned on?
"Troubleshooting" (P. 30)
When the TV cannot find the digital channels
Check the following points
Is the TV connected correctly to the aerial?
Change the direction of the indoor aerial.
Is there a digital channel transmission tower nearby?
Turn "Attenuator" to "On" (P. 22), since the radio waves are too strong.
Note
"Attenuator" attenuates the radio waves of analogue signals as well as those of digital broadcast. If some
noise or snow appears when watching an analogue channel, set "Attenuator" to "Off".
Register digital channels again. "Service Scan" (P. 27)
If you cannot yet watch digital channels after following the steps above, there may be a problem
with your aerial or its cable. Or, the signal may be too weak.
When the digital channel reception is poor
The "Missing or weak signal" message appears.
Check the following points
Is the TV connected correctly to the aerial?
Change the direction of the indoor aerial.
Is there a digital channel transmission tower nearby?
Turn "Attenuator" to "On" (P. 22), since the radio waves are too strong.
Note
"Attenuator" attenuates the radio waves of analogue signals as well as those of digital broadcast. If some
noise or snow appears when watching an analogue channel, set "Attenuator" to "Off".
Check digital channels signal. "Signal Check" (P. 27)
If you cannot yet watch digital channels after following the steps above, there may be a problem
with your aerial or its cable. Or, the signal may be too weak.
When "RF Attenuator" setting screen is displayed
Set "Attenuator" (P. 22) from this setting screen.
To set the "Attenuator" on, select "On." To set it off, select "Off."
This setting screen will appear during the "Factory Settings (P. 27) with "Attenuator" set to "On."
Consult your retailer
Consult your retailer
11