Table of Contents
Advertisement
ASSEMBLY
2.5 ATTACH CHIPPER EXTENSION (CE
COMPLIANT MODELS ONLY)
1. Slide the chipper extension into the chipper chute
aligning the mounting holes.
2. Secure using four 5/16" x 3/4" carriage bolts, 5/16"
nylock nuts and 5/16" flat washers. (See Figure 2.7.)
Figure 2.7, Chipper extension and Shredder chute tray
2.6 ATTACH SHREDDER CHUTE TRAY
1. Align the shredder chute tray on the shredder chute so
that the chute sits on top of the hinge.
2. Attach the shredder chute with the supplied four 5/16"
x 3/4" carriage bolts, 5/16" nylock nuts and 5/16" flat
washers. (See Figure 2.5.)
2.7 INSTALL A BATTERY
You will need to purchase a battery. Choose a battery that
meets or exceeds the engine manufacturer's specifications.
Consult your engine owner's manual or authorized dealer
for specification details.
To install the battery:
1. Open the battery box and insert battery into the battery
box.
2. Attach the positive (red) battery cable from the engine
to the positive (+) battery terminal.
3. Attach the negative (black) battery cable from the
engine to the negative (-) battery terminal.
4. Secure the cover on the battery box with the strap.
WARNING
To avoid sparks and a possible explosion or fire due
to a short circuit, do not touch the positive (+) bat-
tery terminal and any surrounding metal with tools,
jewelry or other metal objects. When installing bat-
tery cables, connect the positive (+) cable first and
the negative (-) cable last.
8
2.8 ADD MOTOR OIL
Check the oil level and, if needed, fill the engine crankcase
with the type and amount of oil specified in the engine
owner's manual.
2.9 FILL THE FUEL TANK
or less with a pouring spout is recommended. Do not fill the
fuel tank while the engine is hot or running, since spilled fuel
could ignite if it comes in contact with hot parts or sparks from
ignition. Do not start the engine near spilled fuel. Never use
fuel as a cleaning agent. DO NOT MIX OIL WITH FUEL.
Use only those types of fuels that are recommended in
your engine owner's manual.
To add fuel:
1. Stop engine, wait for all parts to stop moving and
disconnect spark plug wire. Remove key from key
switch. Allow the engine and muffler to cool for at least
three minutes.
2. Clean area around fuel fill cap and remove cap.
3. Using a clean funnel, fill fuel tank to 1/2" below bottom
of filler neck to provide space for any fuel expansion.
Install fuel fill cap securely and wipe up any spilled
gasoline.
5 INCH CHIPPER/SHREDDER/BLOWER
Figure 2.8, Engine oil fill
WARNING
Gasoline and diesel fuels are highly flammable and
their vapors are explosive. To prevent personal
injury or property damage:
Store fuel only in approved containers, in well
ventilated, unoccupied buildings, away from sparks
or flames. A container with a capacity of 2 gallons
Advertisement
Table of Contents
