Kenwood DNR1008RVS Quick Start Manual page 35

Ñ
3-way speaker system setup
Subwoofer Preout
Mid Range Preout
Tweeter Preout
When connecting to an external amplifier,
connect its ground wire to the car's chassis to
avoid damaging the unit.
Preout
RCA Cable
(Sold separately)
Power amplifier
(optional
accessory)
Input
White
+
White/Black
Gray
+
Gray/Black
Green
+
Green/Black
Purple
+
Purple/Black
Speaker impedance: 4-8 Ω
NOTE
• For speaker system setup, see 3-way speaker
system setup (P.74) in the Instruction Manual.
• For speaker setup and crossover setup, see
Speaker / X'over setup (P.75) in the
Instruction Manual.
• For how to connect speaker wires to terminals
other than speaker terminals and Preout
terminals, see Connecting the system and
external components (P.35) and Connecting
wires to terminals (P.34).
Speaker
To mid range left
speaker
To mid range right
speaker
To tweeter left speaker
To tweeter right
speaker
Ñ
Connecting the system and
external components
10 9
1
2
3
4
1 Accessory 3: Bluetooth Microphone
FM/AM antenna input
2
AV Audio output (ø3.5 mini jack)
3
When connecting to an external amplifier,
4
connect its ground wire to the car's chassis to
avoid damaging the unit.
Rear Audio Preout
(Left; White, Right; Red)
Front Audio Preout
(Left; White, Right; Red)
Subwoofer Preout
(Left; White, Right; Red)
SiriusXM Connect Vehicle Tuner connector
5
For more information on how to install the
SiriusXM Connect Vehicle tuner, consult the
installation guide included with the tuner.
Connection/Installation
15
14
13
12
11
8 7 6
5
English
35