To start the engine:
▼ Check that the engine stop switch is
in the RUN position.
▼ Make sure that the transmission is in
neutral.
▼ Turn the ignition switch ON.
▼ Pull the clutch lever fully into the
handlebar.
▼ Leaving the throttle fully closed,
push the starter button until the
engine starts.
The motorcycle is equipped with starter
lockout switches. The switches prevent
the electric starter from operating when
the transmission is not in neutral with
the side stand down.
If the side stand is extended while the
engine is running, and the transmission
is not in neutral then the engine will
stop regardless of clutch position.
Note
The
instrument
illuminate and will then go off (except
those which normally remain on until
the engine starts, see page 42).
A transponder is installed within the key
to turn off the engine immobilizer. To
make
sure
that
functions correctly, always have only
one of the ignition keys near the ignition
switch. Having two ignition keys near
the switch may interrupt the signal
between
the
transponder
engine immobilizer. In this situation the
engine immobilizer will remain active
until one of the ignition keys is removed.
HOW TO RIDE THE MOTORCYCLE
warning
lights
will
the
immobilizer
and
the
Moving Off
To move the motorcycle:
▼ Pull in the clutch lever and select
first gear.
▼ Open the throttle a little and let out
the clutch lever slowly.
▼ As the clutch starts to engage, open
the throttle a little more, allowing
enough
engine
stalling.
speed
to
avoid
111