Installing An Optional Floppy Or Fixed Hard Drive - Bosch DIVAR IP 6000 2U Installation Manual

16 en | Chassis setup and maintenance
Notice!
We recommend using the respective Bosch hard disk drives. The hard disk drives as one of
the critical component are carefully selected by Bosch based on available failure rates. HDD –
not delivered from Bosch – are not supported. Information on supported HDDs can be found
in the datasheet in the Bosch Online Product Catalog.
3.3

Installing an optional floppy or fixed hard drive

The chassis models include two open slots for an optional floppy drive, and/or hard disk
drive(s). To utilize these slots, the dummy drive and the slot cover must be removed.
To remove the dummy drive or hard disk drive:
1.
2.
3.
4.
2014.01 | V2 | DOC
Disconnect the chassis from any power source.
Press the release tab.
Push against the back of the dummy drive, sliding the dummy drive and slot cover
forward, out through the front of the chassis.
Insert the drive into rear of the open slot and connect the wiring.
Installation Manual
DIVAR IP 6000 2U
Bosch Sicherheitssysteme GmbH