National Instruments USB-621 Series User Manual page 191

Glossary
single-ended output
software triggering
source impedance
synchronous
T
task
TC
terminal
terminal count
t
gh
t
gsu
t
gw
Timebase
t
out
transducer
NI USB-621x User Manual
A circuit whose output signal is present between one output terminal and
ground.
A method of triggering in which you simulate an analog trigger using
software. Also called conditional retrieval.
A parameter of signal sources that reflects current-driving ability of voltage
sources (lower is better) and the voltage-driving ability of current sources
(higher is better).
1. Hardware—A property of an event that is synchronized to a reference
clock.
2. Software—A property of a function that begins an operation and
returns only when the operation is complete. A synchronous process is,
therefore, locked and no other processes can run during this time.
In NI-DAQmx, a collection of one or more channels, timing, and triggering
and other properties that apply to the task itself. Conceptually, a task
represents a measurement or generation you want to perform.
See terminal count.
An object or region on a node through which data passes.
The highest value of a counter.
Gate hold time.
Gate setup time.
Gate pulse width.
The reference signals for controlling the basic accuracy of time or
frequency-based measurements. For instruments, timebase refers to the
accuracy of the internal clock.
Output delay time.
A device that responds to a physical stimulus (heat, light, sound, pressure,
motion, flow, and so on), and produces a corresponding electrical signal.
See also sensor.
G-14 ni.com