Husqvarna PG 830S Operator's Manual page 22

• During transportation, the grinding head must be
on the ground. To prevent damage to the lock
mechanism of the tool plates, keep the tool plates
installed.
To set the product in transport position
• Fold down the handle. Refer to
and the handlebar on page 13 .
• If the weights are attached to the product, adjust the
weights to forward position. Refer to
weights on page 17 .
• Make sure that the grinding head touches the
surface.
To move the product up and down a
ramp
WARNING:
move the product up and down ramps with
the motor on. The product is heavy and
there is a risk of injury if the product falls
or moves too quickly.
WARNING:
slope, always use a winch. Do not walk or
stay below the product. Do not stay in the
product risk area. Refer to
on page 6 .
WARNING:
on steep slopes. Look at the rating plate
on the product for information about the
maximum slope angle.
• To move the product down a ramp, operate the
product rearward slowly.
• To move the product up a ramp, operate the product
forward slowly.
• Do not turn the product more than 45° on a ramp.
To lift the product
WARNING:
equipment has the correct specification to lift
22
To adjust the handle
To adjust the
Be very careful when you
For ramps with a steep
Work area safety
Do not move the product
Make sure that the lifting
the product safely. The rating plate on the
product shows the product weight.
WARNING:
or near a lifted product. Keep bystanders
away from the risk area. Refer to
safety on page 6 .
WARNING:
product. Make sure that the lifting eye is
correctly installed and not damaged.
1. Set the product in transport position. Refer to
the product in transport position on page 22 .
2. Attach the lifting equipment at the lifting eye.
To attach the product to a
transportation vehicle
The product has holes that are used with tie-down
straps to attach the product to the transportation vehicle.
1. Attach the tie-down straps in the holes.
4X
2. Attach and tighten the tie-down straps to the vehicle.
Storage
CAUTION:
storage outdoors. Always keep the product
indoors.
• Keep the product in a dry and frost free area.
• Clean the product and do a complete servicing
before you put the product in storage.
Do not walk or stay below
Work area
Do not lift a damaged
To set
Do not put the product in
1253 - 004 - 09.12.2022