Midea MAW08V1QWT Installation Manual

Installation Guide
Scan the following QR code for an installation video.
Window Type
Air Conditioner
Models
MAW08V1QWT
You must follow the user manual for
MAW10V1QWT
detailed installation instructions
MAW12V1QWT
Before using your air conditioner, please read
the user manual carefully and keep for future
reference. For additional support, please call
customer service at 1-866-646-4332.
version A - 03 - 2020
Installation Guide Page 1
TOOL & HARDWARE
Required Installation Hardware Optional Installation Hardware
1/2" Type B Screw 2
1/4" Type B Screw 2
Main Bracket 1
Right Extension Arm
1
(For 26"-36" windows)
Right Extension Arm – Short
1
(For 22"-26" windows)
Main Support Pin 2
Cotter Pin 2
1/2" Type A Screw 3
Open Window Bracket – RH 1
Do not use any devices or materials for
Open Window Bracket – LH 1 installation that are not recommended in
this manual.
Side Arm Foam 2
WINDOW REQUIREMENTS
SEAL FOAM
22" to 36"
(558 mm to 914mm)
13.75" min
INNER
(349 mm)
WINDOW SILL
INTERIOR
WALL
Wooden Windows
OUTSIDE
INSIDE
INSIDE
Wooden Windows Vinyl-Clad Windows
NOTICE
Maximum window thickness including
non-removable handle: 2-7/8"
Page 2
1. INSTALL THE SUPPORT BRACKET
WARNING
• Bracket should only be used for its intended purpose. If not, the warranty will be voided.
Window Sash Lock
1
• You must follow the detailed installation instructions in the user manual.
Thick Window Sash Seal Foam 1
Thin Window Sash Seal Foam 1
Miscellaneous Sealing Foam 1
Additional Side Arm Foam 2
1" Type A Screw 2
WARNING
Left Extension Arm
SEAL FOAM
22" to 36"
(558 mm to 914mm)
13.75" min
(349 mm)
INNER
WINDOW SILL
Vinyl-Clad Windows
Vinyl Lip
OUTSIDE
Spring Pin Locks
1.1 Adjust the left extension arm out and install
the right extension arm. Set the bracket in
your window.
Right
Extension
Arm
Horizontal Bracket
WARNING
Maintain control of the bracket until
installation is complete.
1.2 Adjust the angled support arms until
Depending on the
they touch the exterior wall. Check that
level used, place at
the bracket is properly tilted downwards
either location below
toward the outdoors. Install the support
to check level.
pins and cotter pins then extend the left
and right extension arms.
Center this part of the
bracket with the center
of the windows.
Extend the Extension Arms until they touch the
Windowsill and the Spring Pin locks in place.
Spring
Cotter Pin
Pin
Locks
Page 3 Installation Guide