Steering Stem - KYMCO Zing 125 Service Manual

11
. FRONT WHEEL/SUSPENSION/
STEERING
INSTALLATION
Install the front fork tubes into the upper and
lower fork bridges and the front right and left
turn signal light holders.
Install and tighten the attaching bolts.
Front Fender Installation
Install the front fender between the front fork
tubes, then install and tighten the four bolts.
Torque: 0.8～1.2kg-m

STEERING STEM

REMOVAL
Remove the handlebar. (Refer to 11-3.)
Remove the front fork tubes. (Refer to
11-10.)
Remove the steering stem nut using the lock
nut wrench.
Remove the bearing adjusting nut, top cone
race, steering stem and steel balls.
＊ ＊ ＊ ＊
Place the steel balls in a parts tray so that
they are not lost.
Bolts
Front Fender
Lock Nut Wrench, 30x32mm
Steering Stem Wrench 5008422
11-14