Steering Handlebar/Front Wheel/Front Brake/Front; Steering Handlebar - KYMCO DINK50 Service Manual

13
. STEERING HANDLEBAR/FRONT WHEEL/FRONT
BRAKE/FRONT SHOCK ABSORBER/FRONT FORK
Brake Master Cylinders

STEERING HANDLEBAR

REMOVAL
Remove the handlebar front and rear covers.
(  2-6)
Remove the front and rear brake master
cylinder attaching bolts.
Remove the front upper cover. (  2-5)
Remove the front lower cover. (  2-5)
Remove the floor board. (  2-4)
Remove the leg shield. (  2-5)
Bolts
Throttle Grip
Remove the four screws attaching the right
and left handlebar switches.
Disconnect the throttle cable from the throttle
grip and remove the throttle grip from the
handlebar.
Screws Throttle Cable
Remove the handlebar lock nut and take out
the bolt.
Remove the handlebar.
Lock Nut
Bolt
Collar
INSTALLATION
Install the handlebar onto the steering stem
and install the handlebar collar, lock nut and
bolt.
Tighten the bolt to the specified torque.
Torque: 4.0_ 5.0kg-m
Lock Nut
Bolt
13-4
www.PlanDeGraissage.org