Installing The Battery; Using Your Charger; Charging The Battery; Turning Your Phone On - Motorola V1050 User Manual

Motorola v1050: user manual
Hide thumbs Also See for V1050:
Table of Contents

Advertisement

5.5

5.5 Installing the Battery

Your phone is designed to use only
Motorola Original™ batteries and accessories.
1
2
3
16
Basics
5.9

5.9 Adjusting Volume

Press the up or down
volume keys to:
Volume
• increase or decrease
Keys
earpiece volume
during a call
• increase or decrease speakerphone volume during a
call
• turn off an incoming call alert
• increase or decrease the ringer volume setting when
the home screen is visible
Tip: At the lowest volume setting, press the down
volume key once to switch to vibrate alert. Press it
again to switch to silent alert. Press the up volume key
to cycle back to vibrate alert, then ring alert.
18
Basics
Installing the Battery

5.6 Using Your Charger

The battery charger shipped with this device is specifically
designed for use with Motorola 3G mobile phones. Inserting
a non-compatible charger might cause the phone to shut
down and begin charging at a very slow rate. When an
incompatible charger is attached, you might not be able to
make and receive calls.
Please use only the following charger kits with this device:
• CH620 rapid charger, kit number CFPN1108AB,
including:
- SPN5195A charger (SPN5049A in plastic bag)
- SYN7455A UK plug & SYN7456A Euro plug
• VC600 in car rapid charger, kit number CFLN1306AB –
(includes: SYN0707B)

5.7 Charging the Battery

New batteries are shipped partially charged. Before using
your phone, please install and fully charge the battery as
described below. Some batteries perform best after several
full charge/discharge cycles.
Adjusting Volume

5.10 Making a Call

To make video calls, see page 38.
Press
To
keypad keys
dial the phone number
1
make the call
2
end the call and "hang up" the phone
3
when you are finished
Tip: You can also close the phone to end the call.
Note: You can make an emergency call even when the phone
is locked, or when a SIM card is not inserted (see page 58).

5.11 Answering a Call

When you receive a call, your phone rings and/or vibrates
and displays an incoming call message.
When
is On, open the phone to answer the call.
Open to Answer
M
To set
Answer, press
>
>
Open to
Settings
In-Call Setup
>
>
Answer Options
Open to
Answer.

Turning Your Phone On

Action
Plug the travel
1
charger into your
phone with the
release tab facing
up.
Plug the other end of the travel charger into the
2
appropriate electrical outlet.
When your phone indicates
Complete, press the
Charge
3
release tab and remove the travel charger.
Tip: You can safely leave the travel charger connected to
your phone after charging is complete. This will not damage
the battery.

Changing the Call Alert

If
is Off:
Open to Answer
Press
To
answer the call
1
or
Divert
or
divert the call to your voicemail or call
divert number, as though your line
was busy
end the call and "hang up" the phone
2
when you are finished
5.12 Changing the Call Alert
M
To set your
Style, press
>
>
(see
Ring
Settings
Ring Styles
page 54).
Shortcut: In the home screen, press the down volume key to
switch the alert for incoming calls and other events to vibrate
alert, then silent alert. Press the up volume key to reset ring
alert.
5.8
5.8 Turning Your Phone On
Action
Open your phone.
1
Press and hold
2
Power
for 2 seconds to
Key
turn on the phone.
S
If necessary, press
to scroll to the User Account
3
you want. Then press the
key to select the
Select
account from the list (stored on the SIM card).
If necessary, enter your SIM card PIN code and press
4
the
key to unlock the SIM card.
OK
Caution: If you enter an incorrect PIN code 3 times in
a row, your SIM card is disabled and your phone
displays
SIM
Blocked.
If necessary, enter your four-digit unlock code and
5
press
key to unlock the phone.
OK
Tip: The unlock code is originally set to 1234. Your
service provider may change this number before you
receive your phone.
Basics
17
5.12

5.13 Viewing Your Phone Number

To view your phone number from the home screen, press
M #
.
M
While you are on a call, press
>
My Tel.
Numbers.
Note: Your phone number must be stored on your SIM card
to use this feature. To store your phone number on the SIM
card, see page 54. If you do not know your phone number,
contact your service provider.
Basics
19

Advertisement

Table of Contents
loading

Table of Contents