Advertisement
1
拆解
Disassembling
键盘需要先拆离假组状态，建议过程如下：
1.1
In order to properly cancel the soft-assembling, following
steps is suggested:
Step 0: 取出测试触发功能
Test PCB trigger function
键盘开发由 LNE 工作室完成，建议使用官方软件 LINK 进行管理
The keyboard development is completed by LNE Studio, and it is
recommended to use the official software LINK for management.
NOTE: 产品默认左手部分与 PC 主机蓝牙通信，右手部分只与左手部分蓝牙通信。
By default, the left-hand part communicates with the PC host via Bluetooth, while the right-hand
part communicates with the left-hand part via Bluetooth.
如主机蓝牙信号良好，可以在接入电池的情况下，打开双手供电开关，使用蓝牙连接主机，
进行触发测试。
If the Bluetooth signal of the host is good, you can turn on both parts' power supply switches
when the battery is connected, connect the host with Bluetooth, and conduct the trigger test.
如主机蓝牙信号不良，可使用 TypeC 线连接左手，打开右手供电开关，使用有线连接主机，
进行触发测试。
If the Bluetooth signal of the host is poor, use the TypeC cable to connect the left hand, turn on
the power supply switch of the right hand, and use the cable to connect the host for the trigger
test.
Advertisement
