Using The Remote Control Unit - Sharp PN-L851H Operation Manual
Hide thumbs
Also See for PN-L851H:
- Software manual (19 pages) ,
- Setup manual (36 pages) ,
- Operation manual (71 pages)
Table of Contents
Advertisement
Basic Operation
Using the remote control unit
1
2
3
4
5
6
7
8
9
10
1. HDMI
Switch the input mode to HDMI1 or HDMI2.
2. Numeric input buttons
0 to 9 are also used in conjunction with the ID SET button.
3. MUTE
Turns off the volume temporarily.
Press the MUTE button again to turn the sound back to the
previous level.
4. MODE (Color mode selection)
Each time you press this button, the color mode changes in
the following order:
STD (Standard) → VIVID → sRGB →
HIGH ILLUMINANCE → STD...
• HIGH ILLUMINANCE is a display with colors suited to
bright locations.
• sRGB is international standard of color representation
specified by IEC (International Electrotechnical
Commission). Color conversion is made in taking account
of liquid crystal's characteristics and represents color tone
close to its original image.
26
E
5. VOLUME +/- (Volume adjustment)
Pressing + or - displays the VOLUME menu.
23
11
12
13
14
Press + or - to adjust the volume.
* If you do not press any buttons for about 4 seconds, the
15
VOLUME menu automatically disappears.
16
17
6. INFORMATION
Displays monitor information.
18
INFORMATION1
19
INPUT MODE
SIZE
20
COLOR MODE
BRIGHT
VOLUME
REMOTE No.
MODEL
VERSION
S/N
STATUS
TOUCH PANEL
3 8 4 0 x 2 1 6 0
INFORMATION2-1
APPLICATION VERSION
MONITOR CONTROL SELECT
Ethernet
IPv4 IP address
IPv4 IP settings
MAC address
Wireless LAN
IPv4 IP address
IPv4 IP settings
MAC address
3 8 4 0 x 2 1 6 0
The display changes from INFORMATION1 →
INFORMATION2-1 → INFORMATION2-2 → INFORMATION3
→ clear display, and so on every time you press this button.
When displaying INFORMATION, the display changes from
INFORMATION1 → INFORMATION2-1 → INFORMATION2-2
→ INFORMATION3 → INFORMATION1, and so on every time
you press the
Pressing the RETURN button disappears the display.
• INFORMATION3 shows the information when you have
used the expansion slot to expand the functions.
• The display disappears automatically after about 15
seconds.
7. FUNCTION
Use this to display the FUNCTION menu. (See page 43.)
01/01/2019 TUE 12:00:00 AM
:
HDMI1
:
WIDE
:
STD
:
31
:
15
:
0
:
PN-L751H
:
X.X.X.X
:
XXXXXXXX
:
0000-000000-00-0000
:
OK
NEXT:[ ]
END:[RETURN]
V: 30 Hz
H: 67.5 kHz
01/01/2019 TUE 12:00:00 AM
:
X.X.XX
:
LAN
:
ON
:
192.168.150.002
:
DHCP
:
XX-XX-XX-XX-XX-XX
:
ON
:
XXX.XXX.XXX.XXX
:
DHCP
:
XX-XX-XX-XX-XX-XX
NEXT:[ ]
END:[RETURN]
V: 30 Hz
H: 67.5 kHz
button.
Advertisement
Table of Contents
