Table of Contents
Advertisement
Before getting started
Assembling the Hydrofoil
A T10 screwdriver (supplied) is needed to assemble the Hydrofoil. Do not over-
tighten the screws.
®
®
©
@
®
1. Remove the elastic band from the hull.
2. Screw the arm onto the hull with 2 screws (diagram A).
3. Insert the MiniDrone support into the slot on the central spindle (diagram B).
4. Screw the central spindle onto the hull with 4 screws (diagram C).
5. Insert the two lateral floats into the ends of the arm.
6. Insert then screw the two lateral fins into the floats with 2 screws (diagram D).
7. Insert then screw the tail fin into the slot located at the rear of the hull with 1
screw (diagram E).
In order to avoid any risk of the Hydrofoil losing its
shape, keep it on its original support.
4
Before getting started
Advertisement
Table of Contents
