Table of Contents
Advertisement
Hot Key Function As (Power Off)
This option allows you to set the Hot Key functionality to one of the following
states: Disable (turn off Hot Key functionality), Power Off, Suspend.
Hot Key Power On Function (Disabled)
When enabled, allows you to power on the system using hot keys.
USB S3 WakeUp Function (Disabled)
This option enables USB device activity to wake the system from S3
HDD Off After (Disable)
The IDE hard drive will spin down if it is not accessed within a specified length
of time. Options are from 1 Min to 15 Min and Disable.
Power Button Override (Instant Off)
Under ACPI (Advanced Configuration and Power management Interface) you
can create a software power down. In a software power down, the system can
be resumed by Wake Up Alarms. This item lets you install a software power
down that is controlled by the power button on your system. If the item is set
to Instant-Off, then the power button causes a software power down. If the
item is set to Delay 4 Sec. then you have to hold the power button down for
four seconds to cause a software power down.
Power State Resume Control (Always Off)
This sets the power state after a shutdown due to an unexpected interrupt of
AC power.
PM Wake Up Events
Scroll to this item and press <Enter> to view the following screen:
CMOS Setup Utility – Copyright (C) 1984 – 2000 Award Software
IRQ [3-7, 9-15], NMI
IRQ 8 Break suspend
Ring/WOL/WOM PowerUp Contl
PCIPME Power Up Control
Power Up by Alarm
x
Month Alarm
x
Date (of Month)
x
Time (hh:mm:ss)
↑ ↓ → ← : Move Enter : Select
F5:Previous Values
This item opens a submenu that enables you to set events that will resume
the system from a power saving mode.
PM Wake Up Events
[Enabled ]
[Disabled]
[Disabled]
[Enabled]
[Disabled]
NA
0
0 0 0
+/-/PU/PD:Value:
F10: Save ESC: Exit
F6:Fail-Safe Defaults
F7:Optimized Defaults
39
Item Help
Menu Level
F1:General Help
Advertisement
Table of Contents
