Cobra microTALK 3175-PDF Owner's Manual page 10

3175-PDF VERSION.qxd
Mode Functions
Operation
Channel Scan
Your microTALK ® radio can automatically scan channels.
To Scan Channels:
Mode Button
1. Press the Mode button until the Scan icon
and the channel numbers flash on the display.
2. Press the Channel Up or Channel Down
button to begin scanning channels.
Scanning Channels
The Scan icon will continue to be displayed when
Channel Button
scan is On. Your radio will continue to scan all
channels and stop if an incoming transmission is
detected. Your radio will remain on that channel
for ten (10) seconds.
While setting channel scan, if you do not
press any buttons for 15 seconds, your radio
will automatically return to Standby mode on
the channel or channel/privacy code displayed
before you entered mode functions.
During Channel Scan (while receiving an incoming transmission),
You Can Choose From The Following:
a. Press and hold the Talk button to communicate on that
channel. Your radio will remain on that channel and return
to Standby mode.
b. Press the Channel Up or Channel Down button to resume
scanning channels.
11/20/03 10:45 AM
The radio ignores specific privacy
codes while scanning channels.
Page 14
Introduction
During Channel Scan (while not receiving a transmission),
•
You Can Choose From The Following:
a. Press and hold the Talk button to communicate on the channel
or channel/privacy code that was displayed before you entered
mode functions or the channel on which, during scanning,
you last received a transmission. This will return the radio
to Standby mode.
b. Press the Mode button to proceed to set privacy code scan on
the channel that was either displayed before you entered mode
functions or on which, during channel scanning, you last
received a transmission (see below for further details).
c. Press the Lock button to return to Standby mode on the
channel/privacy code that was displayed before you entered
mode functions or the channel on which, during scanning,
you last received a transmission.
Privacy Code Scan
Your microTALK
(00 through 38) within one (1) channel.
Select Channel
Mode Button
Scan Privacy Codes
Operation Customer Assistance
® radio can automatically scan the Privacy Codes
To Scan Privacy Codes:
1. While in Standby mode, press the
Channel Up or Channel Down button to
choose the channel on which you wish
to scan privacy codes.
2. Press the Mode button until the Scan icon and
the privacy code numbers flash on the display.
3. Press the Channel Up or Channel Down
button to begin scanning privacy codes
Warranty
•