Wiring - Siemens SIMATIC S7-1500 Equipment Manual

Wiring

This section contains the block diagram of the module and outlines various wiring options.
You can find information on wiring the front connector, creating a cable shield, etc. in the
Wiring section of the system manual S7-1500/ET 200MP
(https://support.industry.siemens.com/cs/ww/en/view/59191792).
Note
Do not insert the potential jumpers included with the front connector!
Wiring and block diagram
The example in the following figure shows the terminal assignment and the assignment of
the channels.
① Backplane bus interface
Figure 3-1
12
Block diagram and terminal assignment
Digital output module DQ 8x230VAC/2A ST Triac (6ES7522-5FF00-0AB0)
CHx Channel or channel status LED (green/red)
RUN Status display LED (green)
ERROR Error display LED (red)
Equipment Manual, 12/2021, A5E03485733-AE
3