Midland Olympian MO-1008 User Manual page 16

stopped on a non-priority channel, the radio will continue to
check for activity on the priority channel. This is called priority
channel lookback, and the receive audio from the non-priority
channel will be briefly interrupted while priority lookback occurs.
While the radio is stopped on a non-priority channel it may be
deleted from the scan list by pressing a programmed Scan Skip
or Monitor function button. This is the nuisance channel delete
function. The priority channel can not be deleted from the scan
list. When the radio is turned off, all channels removed from the
scan list using nuisance channel delete will be restored.
Priority Select Scan
If channel select priority scan has been programmed by your
dealer or communications coordinator, the channel selected
when scan is turned on will be assigned as the priority channel.
Operation will otherwise follow the priority channel scan
conventions.
Transmitting While in Scan Mode
If PTT is pressed while the radio is in scan mode, your dealer or
communications coordinator may have programmed one of the
following options for the transmit channel:
When PTT is pressed, the radio will generate an error beep
1.
because your dealer or communications coordinator has
programmed the radio to not allow transmission while the
radio is in scan mode.
When PTT is pressed, the radio will switch to and transmit
2.
on the priority 1 channel, priority 2 channel or other dealer
programmed channel regardless of the current receive state.
This mode may be referred to as priority only transmit.
If the radio has stopped on a channel, or the scan hang
3.
timer is active, the radio will transmit on the scan stop
channel when you press PTT. If you press PTT, while the
radio is scanning channels, the radio will switch to and
transmit on the priority 1 channel, priority 2 channel or other
16
Olympian™ Mobile User's Guide
© 2005, Midland Radio Corporation