Table of Contents
Advertisement
Note : The unit will automatically go to normal mode after 5 seconds of no button activity
during menu setting.
Channel Selection : Your G-300 has 22 channels available. To change channels:
•
With the radio on, press
flashes.
•
Use the
•
Press the PTT button to save the new channel.
CTCSS Selection : Your G-300 has 38 CTCSS codes available. The selected
CTCSS code may be different for each channel. To select a CTCSS code for the
current channel:
•
With the desired channel selected, repeatedly press
current CTCSS Code number or "oF" flashes.
•
Use the
•
Press the PTT button to save the new CTCSS Code or press the
repeatedly until you exit the menu.
Note : Selecting a CTCSS code of "oF" will disable the the CTCSS feature. To
communicate between two , both the channel and CTCSS code selections must be
the same. To communicate with other models and brands of radios the actual radio
frequency and CTCSS frequency must be matched. The frequency chart at the back
of this book are included to help with this selection. In general, the first fourteen
channel selections may be used to communicate with most FRS radios.
Power Selection : Your G-300 has two transmit power levels. To select the power
level on channels 1~7 and 15~22:
•
Press
until the "Pr" appears on the display.
•
Press
or
Hi/Lo icon will alternately appear during setting.
•
Press the PTT button to save and exit.
The HI or LO icon will appear on the display depending on your setting.
Note : On channel 8~14 no power level selection is possible
VOX : VOX (voice operated transmit) operation allows you to transmit without using
the PTT button when using a headset. To enable VOX operation:
•
Insert the headset plug(s) into the SPK/MIC jacks.
•
Set the radio into VOX mode.
To set the radio to VOX Mode, repeatedly press the
flashes on the LCD display. Press the
an "on" or "oF" will appear on the display during setting. The VOX icon will appear
on the LCD display if the radio is set into VOX mode.
Vibrate Alert (G-300 only): Your G-300 is equipped with a Vibrate alert for silent
operation of the radio. The radio will vibrate when receiving a call tone transmission
instead of emitting a call tone sound. To set the unit at Vibrate alert mode:
•
Press the
display.
•
Press the
"on" or "oF" will appear on the display during setting.
•
Press the PTT button to save and exit.
The Vibrate alert icon will appear on the display when unit is in vibrate mode.
Roger Beep Tone : Whenever you release the PTT button, a "Roger Beep" tone
may be transmitted to let your friends know you are finished talking. To enable the
Roger Beep, press the
Press the
and
will appear on the display during setting.
until the current channel segment
or
buttons to change the channel.
or
button to change the CTCSS code number.
to select between high and low power levels. The
or
button to turn the VOX on or off,
button repeatedly until the Vibrate icon flashes on the
or
button to set the Vibrate alert on or off, an
button repeatedly until the "rb" appears on the display.
to set the Roger Beep tone on or off. An "on" or "oF"
until the
button until the VOX icon
Advertisement
Table of Contents
