Table of Contents
Advertisement
This section provides information on installing the ArtixScan 2500 on the Macintosh. The procedures are divided
into two main sections: 1) Installation for Macintosh computers that feature built-in SCSI ports; and 2) Installation
for Macintosh G3 or G4 computers without SCSI ports/cards. For these computers, you will be installing the SCSI
interface card included with your scanner package.
A. Installation for Macintosh computers that feature built-in SCSI ports
1. Connecting the scanner
1. Shut down your computer.
2. Connect the scanner to your computer, using the
SCSI cable provided in the scanner package.
Note: See the next section for details on termination.
3. Plug the power cord to the power connector at the
back panel of the scanner, and plug the other end of
the power cord to your AC power source or wall
outlet.
4. Turn on your scanner and wait for all the lights on
the front panel to stop blinking and stay on steady.
5. Power up your Macintosh.
3 Installation on the Macintosh
2. Termination
1. If the scanner is the last device on the SCSI chain, set
the internal terminator switch on the back of the
scanner to the "ON" position. There is no need to
install an external terminator on any of the other
SCSI devices on the chain.
2. If the scanner is not the last device on the SCSI
chain:
• Make sure the internal terminator switch located
at the back of the scanner is set to the "OFF"
position.
• Make sure the last device on the SCSI chain is
terminated.
ArtixScan 2500 Installation and Operation Manual
ON
OFF
7
Advertisement
Table of Contents
