HELIX DSP PRO Manual page 15

Initial start-up and functions
1 Line Input
2 Coax Input
Coaxial input in SPDIF format for connecting sour-
c es with a digital audio output. The sampling rate
of this input has to be in the range of 12 and 192
kHz. The input signal is automatically adjusted to
me of this input, we recommend to use an optional
remote control.
Notice: This processor can only handle stereo input
signals and no Dolby-coded digital audio stream.
3 Input Switch
With the Input Switch it is possible to choose bet-
ween the Coax Input" and „Optical Input". It is not
possible to use both inputs at the same time.
4 Optical Input
Optical input in SPDIF format for connecting signal
sources with a digital audio output. The sampling
rate of this input must be between 12 and 192 kHz.
The input signal is automatically adjusted to the in-
ternal sample rate.
commend to use an optional remote control.
Notice: This processor can only handle stereo input
signals and no Dolby-coded digital audio stream.
5 Clipping LED
This LED lights up red if one of the eight „Line In-
signals.
6 Highlevel Input
Use this input to connect the processor directly to
loudspeaker outputs of OEM / aftermarket radios
- der to guarantee a perfect operation in combination
Attention: Solely use the pluggable screw-terminal
7 Power Input
This input is used for connecting the processor
in / out.
remote input can be left unconnected. The remote
-
Attention: Solely use the pluggable screw-terminal
Important: Never use a different signal than the
remote output of the DSP to activate connected
-
-
-
-
15