Closed Captions ...16 On-Screen Control Adjustments (Picture) ...17 Setting Parental Control ...18 • MPAA Rating Set Up ...19 • TV Parental Rating Set Up...20 • Changing the Password for Parental Control...21 Setting the On Timer...22 Troubleshooting Guide ...23 Reception Disturbances ...24 Specifications ...25...
IMPORTANT SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. TO PREVENT ELECTRIC SHOCK, MATCH THE WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERTED.
Page 4
IMPORTANT SAFETY INSTRUCTIONS (CONTINUED) 13. LIGHTNING To protect your product from a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges.
FRONT VOLUME +/– Buttons - Press to raise or lower the volume, or to adjust the Menu options. Power Button - Press to turn the TV on. Press again to turn the TV off. Remote Sensor CHANNEL +/– Buttons - Press to select a channel.
AUDIO/VIDEO IN Jacks - Audio and Video signal cables from an external source can be connected here. AV button must be set to AV. VHF/UHF IN Jack - Connect a VHF/UHF antenna, CATV, VCR, satellite, etc. cable to this jack. AV button must be set to TV/CATV. Power Button MUTE Button CHANNEL +/–...
BATTERY PRECAUTIONS NOTES: • When there is an obstacle between the TV and the transmitter, the transmitter may not operate. • When direct sunlight, incandescent lamp, fluorescent lamp or any other strong light shines on the REMOTE SENSOR of the TV, the remote operation may be 30°...
Follow the connections shown below. With the switch in the “B” position, you can directly tune any nonscrambled channels on your TV. With the switch in the “A” position, tune your TV to the output of the converter/descrambler box (usually channel 3 or 4) and use the converter/descrambler box to tune scrambled channels.
OUTDOOR ANTENNA CONNECTIONS OUTDOOR VHF/UHF ANTENNA CONNECTION (ANTENNA NOT SUPPLIED) Follow the instructions for the type of antenna system you intend to use. If using Cable or Satellite, see page 7. Combination VHF/UHF Antenna (Single 75 ohm cable or 300 ohm twin–lead wire) VHF/UHF 75 Ohm Connect the 75 ohm cable from...
1. Connect the cable, satellite or incoming antenna to the VHF/UHF IN jack on the rear of the VCR. 2. Connect a 75 ohm coaxial cable from the VCR’s 75 ohm OUT jack to the ANT jack on the rear of the TV.
This TV can show the On-Screen display in English or Spanish. Press the Power button to turn on the TV. Press the MENU button ; the MENU screen will appear. Press the Navigation ( )/(◗) buttons LANGUAGE and then the Navigation (❖) button the desired language (English or Spanish).
Press the Power button to turn on the TV. Press the MENU button ; the MENU screen will appear. PICTURE P. LOCK TIMER PRESET EXTRA Press the Navigation ( )/(◗) buttons to select CLOCK. NOTE: If the time has not been set, it will only allow you to select CLOCK.
SETTING THE CHANNELS INTO MEMORY This TV is equipped with a channel memory feature which allows channels to skip up or down to the next channels set into memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the TV’s memory. In addition to normal VHF/UHF channels, this TV can receive up to 113 Cable TV channels.
After setting channels into memory, you can add or delete channels as follows: Press the Power button to turn on the TV. Press the MENU button ; the MENU screen will appear. TO ADD A CHANNEL Press the Navigation ( )/(◗) buttons Press the Navigation (❙)/(❖) buttons...
Set the AIR/CABLE Menu Option as described on page 11. For proper operation, before selecting channels, they must be set into the TV’s program memory, see page 12. Press and release the CHANNEL + or – automatically stops at the next channel set into memory.
TV OPERATION (CONTINUED) SLEEP To set the TV to turn off after a preset amount of time, press the SLEEP button on the remote, “30 MINUTES” will appear on the screen. Each additional press will increase the Sleep time by 30 minutes up to 180 minutes.
• Some cable systems and copy protection systems may interfere with the Closed Caption signal. • If using an indoor antenna or if TV reception is very poor, the Closed Caption Decoder may not appear or may appear with strange characters or misspelled words. In this case, adjust the antenna for better reception or use an outdoor antenna.
ON-SCREEN CONTROL ADJUSTMENTS (PICTURE) Press the Power button to turn on the TV. Press the MENU button ; the MENU screen will appear. Press the Navigation ( )/(◗) buttons to select the desired picture setting (CONTRAST, BRIGHT, COLOR, TINT or SHARPNESS.
You can set the CHANNEL BLOCK to block out any channels that you do not want to be viewed as follows: Press the Power button to turn on the TV. Press the MENU button ; the MENU screen will appear.
SETTING PARENTAL CONTROL (CONTINUED) MPAA Rating enables parents to prevent their children from watching inappropriate material on TV. MPAA Rating reads the ratings for programming (except for news, sports, unedited movies on premium cable and emergency system signals), then denies access to programming if the program’s rating meets the limitations previously set. In this case, the program will be blocked.
SETTING PARENTAL CONTROL (CONTINUED) TV Parental Guidelines have one or more letters added to the basic rating to let parents know when a show contains higher levels of violence, sex, adult material or suggestive dialog. TV PARENTAL RATING SET UP Press the Power button to turn on the TV.
SETTING PARENTAL CONTROL (CONTINUED) CHANGING THE PASSWORD FOR PARENTAL CONTROL Press the Power button to turn on the TV. Press the MENU button ; the MENU screen will appear. Press the SET button and the “ENTER CODE” text will change from blue to red. When it is red, enter the OLD...
IMPORTANT: The TV MUST be turned off using the remote control in order for the On Timer to turn the unit on at the preset time. Press the Power button to turn on the TV. Press the MENU button ; the MENU screen will appear.
Picture control is not adjusted. Possible local interference. Antenna/CATV connector is not connected. TV station experiencing problems. Picture wobbles or drifts. Cable TV channel is scrambled. Possible local interference. CATV not connected. No CATV reception. AIR/CABLE option set to TV.
Outdoor antennas are recommended for best results if not using cable or a satellite. The most common types of television interference are shown below. If one of these symptoms appear when the TV is connected to a Cable TV system, the disturbance may be caused by the local cable company broadcast.
WWW.MEMCORPINC.COM OR CONTACT CUSTOMER SERVICE AT 1-800-919-3647. PLEASE KEEP ALL PACKAGING MATERIAL FOR AT LEAST 90 DAYS IN CASE YOU NEED TO RETURN THIS PRODUCT TO YOUR PLACE OF PURCHASE OR MEMOREX. FOR PARTS AND ACCESSORIES, CONTACT FOX INT’L AT 1-800-321-6993.
Page 27
Memcorp, Inc. Weston, FL Printed in Hong Kong Visit our website at www.memcorpinc.com...