Table of Contents
Advertisement
6-5 Test Procedure
6-5-1 Change the test mode
A. To change the phone's state from Normal Mode to Test Mode, You should press following keys.
" 4 7 * 6 8 # 1 3 5 8 0 "
B. To Enter suspend mode press "001"
C. Press "021" then You can set channel " 2xxxx "
Example : "2 0363"
and press the right soft key(Soft2 key) to save mode/channel value..
D. To finish the Test Mode, You should enter the command "002".
6-5-2 Channel selection and Tx power output level control
A. Enter to Test Mode [ 4 7 * 6 8 # 1 3 5 8 0 ]
B. "001" : Suspend.
C. "009" "0363" [ Push the right soft key ] : Set to '0363' channel.
D. "007" : Carrier On.(TX On)
E. "014" : Spread spectrum to 1.23MHz band width.
F. "016" " xxx " : Adjust RF power level. "xxx" means AGC level (000~ 511)
G. To finish the Test Mode, You should enter the command "002".
Channel number
Mode : CDMA
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
6-5
Test Procedure
Advertisement
Table of Contents
