Samsung SCH-N500 Service Manual page 21

Command No Command SW Name
128 T_CDMA_SET_IM2_I
132 T_TEST_SET_PA_RANGE_I
T_TEST_SET_LNA_RANGE_
133
I
T_TEST_SET_LNA_OFFSET
134
_I
146 T_READ_ADJUST_VAL_I
147 T_PA_WARMUP_DELAY_I
148 T_TX_WARMUP_DELAY_I
150 T_CDMA_LNA_RISE_I
151 T_CDMA_LNA_FALL_I
152 T_CDMA_LNA_2RISE_I
153 T_CDMA_LNA_2FALL_I
154 T_CDMA_LNA_3RISE_I
155 T_CDMA_LNA_3FALL_I
T_VCO_COARSE_TUNE_TA
156
BLE_I
157 T_RFR_BB_FILTER_I
171 T_FAC_RXRAS_ADJ_I
172 T_FAC_HIGH_TXRAS_ADJ_I
173 T_FAC_TXRAS_ADJ_I
174 T_FAC_CH_FLATNESS_I
175 T_FAC_TXRAS_ADJ_ALL_I
224 T_MRU2_TABLE_I
227 T_PLINE_I
230 T_SNDPINFO_I
231 T_READ_RSSI_I
233 T_VOC_PCMLPON_I
234 T_VOC_PCMLPOFF_I
236 T_GET_MODE_I
237 T_SET_MODE_I
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Description
/* Set IM2 */
/*Set PA range*/
/*Set LNA range*/
/*Set LNA offset*/
/*LNA rise and fall setting*/
/* LNA rise and fall setting*/
/* LNA rise and fall setting*/
/* LNA rise and fall setting*/
/* LNA rise and fall setting*/
/* LNA rise and fall setting*/
/* Set VCO table */
/* RFR baseband filter */
/* Factory RX RAS */
/* High gain factory TX pwr RAS */
/* Low gain factory TX pwr RAS */
/* Factory TX pwr ch. flatness */
/* Factory TX pwr RAS */
/* MRU reset */
/* Product lile information */
/* Send product information 8 character */
/* Read a RSSI */
/* Turn on to play a PCM loop back */
/* Turn off to play a PCM loop back */
/* Get mode CDMA/FM
/* Set mode CDMA/FM
5-7
Circuit Description
autotest */
autotest */