Table of Contents
Advertisement
Open-End Wrench Set: SAE/Metric
t
Socket And Ratchet Set: SAE/Metric
t
THESE INSTRUCTIONS MUST BE FOLLOWED TO ENSURE PROPER INSTALLATION AND OPERATION OF YOUR
JACK. FAILURE TO COMPLY WITH THESE INSTRUCTIONS CAN RESULT IN SERIOUS BODILY HARM AND VOID
PRODUCT WARRANTY. MANUFACTURER WILL ASSUME NO LIABILITY FOR LOSS OR DAMAGE OF ANY KIND,
EXPRESSED OR IMPLIED, RESULTING FROM IMPROPER INSTALLATION OR USE OF THIS PRODUCT.
STEP 1
Selecting Site
Before installing your new jack, check the following:
1. JACK LOCATION: Always make sure that adequate
space is available for installation. Your new QuickJack is
shipped in two boxes. Approximate dimensions are shown
below.
2. OVERHEAD OBSTRUCTIONS: The area where the
jack will be located should be free of any overhead
obstructions such as heaters, building supports, electrical
lines etc.
3. DEFECTIVE FLOOR: Visually inspect the site where
the jack is to be installed and check for defective concrete
or asphalt.
STEP 2
Floor Requirements
DO NOT POSITION JACK FRAMES IN THE PATH
FLOOR MUST BE DRY, FLAT, LEVEL AND COMPACT
OF A VEHICLE OR DRIVE OVER JACK FRAMES.
AND HAVE A MINIMUM COMPRESSIVE STRENGTH
PERSONAL INJURY, PRODUCT OR PROPERTY
OF 500 PSI. A LEVEL FLOOR IS REQUIRED FOR
DAMAGE MAY RESULT.
PROPER INSTALLATION AND LEVEL LIFTING.
This jack must be installed on a solid level area with no
more than 3° of slope. Failure to do so could cause
personal injury or death.
TOOLS REQUIRED
IMPORTANT NOTICE
PLEASE READ ENTIRE MANUAL PRIOR TO INSTALLATION
Phillips Screwdriver
t
Wrench sizes: 7/16", 3/8", 5/8", 11/16" and 3/4"
t
1. After choosing the area of installation, open packaging
and remove the frames, handles, hoses and power unit.
2. Place the QuickJack frames near work area.
Installing Cylinder Fittings
1. Remove the shipping plugs from the hydraulic
cylinders as shown below.
9
STEP 3
Unpacking
STEP 4
Advertisement
Table of Contents
