Table of Contents
Advertisement
QUICKJACK CANNOT BE RESPONSIBLE FOR DAMAGE OR INJURY RESULTING FROM, LACK OF MAINTENANCE
OR UNSAFE USE OF THIS PRODUCT.
READ AND UNDERSTAND ALL WARNINGS AND INSTRUCTIONS BEFORE USE. FAILURE TO READ
AND UNDERSTAND THE FOLLOWING WARNINGS MAY RESULT IN PERSONAL INJURY AND/OR
PROPERTY DAMAGE. THIS UNIT IS DESIGNED FOR SERVICING LIGHT DUTY PASSENGER OR
MOTORSPORT VEHICLES ONLY.
t Read all CAUTIONS, WARNINGS, and INSTRUCTIONS included with, or attached to this equipment prior to use.
t Follow all safety precautions to avoid personal injury or property damage during operation.
t Use on hard level floor surface only.
t Always check vehicle gross weight before attempting to use this equipment.
t DO NOT exceed rated load capacity.
t RUBBER LIFT BLOCKS must only be used in the RECEIVER TRAYS.
t DO NOT attempt to raise any load on the upper frame rails. Use RUBBER LIFT BLOCKS only.
t Get familiar with operator controls by running the jacks through a few cycles before loading vehicle on QuickJack.
During prestart testing with no load, the jack frames may not raise and lower evenly. This is normal. During prestart
testing with no load, do not raise frames to full height, raise midway only.
t Visually inspect all components for damage prior to use.
t If any damage is found, DO NOT USE THIS EQUIPMENT.
t All hose couplers must be correctly fastened together before using this equipment or applying pressure.
t NEVER ATTEMPT to connect or disconnect hose couplers while equipment is loaded or hydraulic system is under
pressure.
t Keep dust caps on hose couplers when not in use.
t Use every precaution to guard against dirt entering the system.
t USE CAUTION if using thread sealant or Teflon tape when installing hydraulic fittings/couplers. If using tape, trim any
loose ends to prevent tape from entering the hydraulic system. Care must be taken to ensure that tape or thread
sealant does not enter the hydraulic system. Tape or thread sealant in the fluid will impair fluid flow causing system
malfunction.
t Never exceed the rated capacity.
t Inspect entire unit and all fasteners thoroughly before each use.
t Do not operate this equipment if any component is found to be missing, defective or worn.
t Never operate this equipment with any person in close proximity.
t Always ensure load is centered and secure on each jack frame prior to operation.
t When lowering, pay careful attention that all personnel and objects are kept clear.
t Always keep a visual line of site on vehicle and jack frames during operation.
t Always stand clear when unit is in operation.
t Never leave unit in an elevated position unless both safety lock bars are fully engaged.
t Keep all body parts and objects away from hinge or pinch points when unit is in motion.
t Floor surface must be dry, flat, level and compact and have a minimum compressive strength of 500 PSI.
t Always wear durable work clothing during installation and operation. Loose fitting clothing should be avoided.
t Visually confirm that both safety lock bars are engaged before nearing elevated vehicle.
t DO NOT work under an elevated vehicle unless properly rated vehicle jack stands are used and placed under the
factory approved jacking points.
IMPORTANT OPERATING INSTRUCTIONS
HYDRAULIC POWER SYSTEM WARNINGS:
21
Advertisement
Table of Contents
