Loading; Washer Care; Cleaning Your Washer; Water Inlet Hoses - Maytag Epic MFW9800TQ Use And Care Manual

Epic series front-loading automatic washer
Table of Contents

Advertisement

Available languages

Available languages

Sorting
Separate heavily soiled items from lightly soiled ones, even if they would normally be
washed together. Separate lint-givers (towels, chenille) from lint-takers (corduroy,
synthetics, permanent press). When possible, turn lint-givers inside-out.
Separate dark colors from light colors, colorfast items from noncolorfast items.
Sort by fabric and construction (sturdy cottons, knits, delicate items).
Unloading
Remove clothes from washer after the cycle is completed. Metal objects such as zippers,
snaps, and buckles may rust if left in the washer basket for a long time.
When unloading garments, occasionally check under the gray colored seal at the front of
the tub for small items.

Cleaning Your Washer

Cleaning the exterior
Use a soft damp cloth or sponge to wipe up any spills. Occasionally wipe the outside of your
washer to keep it looking new. Use mild soap and water. Do not use abrasive products.
Cleaning the interior
To keep the interior of your washer clean, run the Sanitary cycle without clothes. Use ½ of the
detergent manufacturer's recommended amount of High Efficiency (HE) powdered or liquid
detergent for a medium-size load.
Cleaning the door seal
Check the fold of the seal periodically for any foreign objects. To clean the seal, mix a dilute
solution, using ¾ cup (177.4 mL) of liquid chlorine bleach, and 1 gal. (3.8 L) of warm tap
water. Wipe the seal area with the dilute solution, using a damp cloth. Let stand 5 minutes.
Wipe down area thoroughly with a dry cloth and let the washer interior air dry with door
open.
IMPORTANT:
Wear rubber gloves when cleaning for prolonged periods.
Refer to the bleach manufacturer's instructions for proper use.
Cleaning the dispenser drawer
The dispenser drawer is removable for easy cleaning.
1. Unlock the dispenser drawer by pressing the Release Lever in the Oxi Prewash
compartment. See "Using the Dispenser." Remove the drawer.
2. Remove the inserts (the siphon from the softener and bleach compartments and the
separator).
3. Wash the parts under running water.
Loading suggestions
Heavy Work Clothes
4 jeans
4 workpants
4 workshirts
Towels
10 bath towels
10 hand towels
Mixed Load
3 sheets (1 king, 2 twin)
4 pillowcases
3 shirts
3 blouses

WASHER CARE

4. Replace the inserts and return the dispenser to the drawer.
Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Periodically inspect
and replace inlet hoses if bulges, kinks, cuts, wear or leaks are found.
When replacing your inlet hoses, record the date of replacement.

Vacation, Storage, and Moving Care

Install and store your washer where it will not freeze. Because some water may stay in the
hoses, freezing can damage your washer. If storing or moving your washer during freezing
weather, winterize it.
Non-use or vacation care:
Operate your washer only when you are at home. If you will be on vacation or not using your
washer for an extended period of time, you should:
Unplug washer or disconnect power.
Turn off the water supply to the washer. This helps avoid unintended flooding (due to a
water pressure surge) while you are away.
Slightly open door to provide ventilation.
To winterize washer:
1. Put 1 qt (1 L) of R.V.-type antifreeze in the drum.
2. Run washer on a Drain/Spin cycle.
3. Unplug washer or disconnect power.
4. Shut off both water faucets.
5. Disconnect water inlet hoses from faucets and drain.

Loading

2 sweatpants
2 sweatshirts
14 washcloths
9 T-shirts
9 shorts
10 handkerchiefs

Water Inlet Hoses

21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents