Furuno WV-100 Operator's Manual page 8

1. OPERATIONAL OVERVIEW
Note 4: If the firewall is not configured, the error message to the below-left appears. Click
[OK], the message to the below-right then appears.
Click [OK] to delete the message, then open the [Enable Firewall for Wave Analyzer] shortcut
on your desktop. If the [User Account Control] dialog appears, click [Yes].
4. To quit the software, click the close button (x) at the upper right corner of the screen. The con-
firmation message "Are you sure you want to exit?" appears.
5. Click [YES] to quit the software.
Check of the setting file at startup
This software checks if the setting file can be read at startup. If the setting file is corrupted, the
following message appears.
• Click [YES] to restore the default settings, then start up the software. The saved settings are
deleted.
• Click [NO] to cancel and close the software.
Attention!
Startup failed because setting file can not be read.
Restore all default settings and restart the software?
NO
(Cancel and exit)
YES
(Restore and restart)
2