Table of Contents
Advertisement
22
www.aeg.com
Problem
DEMO appears on the dis‐
play.
A
or
shown instead of numbers
on the temperature display.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
8.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Possible cause
The food products' tempera‐
ture is too high.
Many food products are stor‐
ed at the same time.
The door has been opened
often.
The Frostmatic function is
switched on.
The Coolmatic function is
switched on.
There is no cold air circula‐
tion in the appliance.
The appliance is in the dem‐
onstration mode.
Temperature sensor prob‐
or
symbol is
lem.
Solution
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces‐
sary.
Refer to "Frostmatic func‐
tion" section.
Refer to "Coolmatic function"
section.
Make sure that there is cold
air circulation in the appli‐
ance. Refer to "Hints and
tips" chapter.
To exit the demonstration
mode, press and hold the
OK button for approximately
10 seconds until you hear a
long sound and the display
turns off for a short time.
Contact the nearest Author‐
ized Service Centre (the
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible).
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to installation instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Advertisement
Table of Contents
