Setup; Switch, Push Button, Connector, And Test Points Descriptions; Table 5-1. Components And Functions - Texas Instruments TPS25762Q1EVM-146 User Manual

Setup

5 Setup
This section describes the various EVM features and how to test these features. Schematic images, pictures,
and block diagrams are provided as necessary.

5.1 Switch, Push Button, Connector, and Test Points Descriptions

Switch, push button, connector, and test points as shown in
Number
S1
J1
J2
J3
J4
J5
J6
J7
J8
J9
J10
J11
J12
J13
J14
J15
J16
J17
J18/J19
J20
Other test points
4 TPS25762/72-Q1 EVM User's Guide

Table 5-1. Components and Functions

Reset push button. Push to reset TPS25762/72-Q1.
NTC input. Can connect to NTC divider or TPL0102 output.
JTAG connector.
NTC pin and SYNC pin to JTAG connector.
Test points of expander GPIOs.
Connect the NTC pin to digital temperature sensor.
2 2
I C mux. Connect I C1 of IC to different devices.
Jumper to connect TVSP pin to different resistor.
USB2ANY connector.
2
I C mux. Connect Aardvark and USB2ANY to I
Aardvark connector.
2
Test point of I C1/2/3.
VIN connector.
GND connector.
From left to right: 5-V buck enable connector; external 5-V VCONN connector;
3.3-V, 1.1-V buck connector.
Choose SYNC mode for TPS55288-Q1.
Micro-B USB connector.
Test point for TIVA JTAG_SWD_SWO signals.
Header to configure GPIO9.
Choose enable signal for TPS55288-Q1.
See marking on PCB board.
Copyright © 2022 Texas Instruments Incorporated
Table 5-1.
Function
2
C1/2/3.
www.ti.com
SLVUC03 – NOVEMBER 2022
Submit Document Feedback