JETWAY P4XFM User Manual page 15

(3) ATX P6 Power Connector (6-pin block) : ATXP9
This is a new defined 6-pins connector that usually comes with ATX Power Supply. The ATX
Power Supply which fully support Pentium 4 processor must including this connector for
support extra 3.3V and 5V voltage to maintain system power consumption. Without this
connector might cause system unstable because the power supply can not provide sufficient
current for system.
(4) PS/2 Mouse & PS/2 Keyboard Connector: PS2KBM
The connectors for PS/2 keyboard and PS/2 Mouse.
(5) USB Port connector: CN1
The connectors are 4-pin connector that connect USB devices to the system board.
(6) LAN Port connector: LAN (only for P4MFP533/P4MFP533T)
This connector is standard RJ45 connector for Network
(7) Parallel Port Connector (25-pin female): PARALL
Parallel Port connector is a 25-pin D-Subminiature Receptacle connector.
Parallel Port can be disabled through the BIOS SETUP.
"INTEGRATED PERIPHERALS SETUP" section for more detail information.
Audio and Game Connector : AUDIO _ GAME
(8)
This Connector are 3 phone Jack for LINE-OUT, LINE-IN, MIC and a 15-pin
D-Subminiature Receptacle Connector for joystick/MIDI Device.
Line-out :
Line-in :
MIC :
Game/MIDI :
(9) Serial Port COM1 : COM1
COM1 is the 9-pin D-Subminiature male connector. The On-board serial port can be disabled
through BIOS SETUP. Please refer to Chapter 3 "INTEGRATED PERIPHERALS SETUP" section
for more detail information.
(10) VGA Connector (15-pin D-Sub) Connector: VGA
(for P4MFM/P4MFMU/P4MFU533/P4MFP533/P4MFU533T/P4MFP533T)
VGA is the 15-pin D-Subminiature female connector for display monitor.
(11) Floppy drive Connector (34-pin block): FDD
Power Connector on Motherboard
Audio output to speaker
Audio input to sound chip
Microphone Connector
For joystick or MIDI Device
PS/2
LAN
Mouse
USB COM1
PS/2
Keyboard
GND
GND
GND
3.3V
3.3V
5V
Power Plugs from Power Supply
PRINT GAME/MIDI PORT
VGA
13
BLK
BLK
BLK
ORG
ORG
RED
The On-board
Please refer to Chapter 3
MIC
LINE-IN
LINE-OUT