Getting Started - Marantz NR1602 Getting Started Manual

TÜRKÇE POLSKI РУССКИЙ
Basic operation of Setup Wizard
Speaker Connection
Please select the
speaker configuration
to be used.
5.1ch
7.1ch
Others
Move to the item that
7.1ch adds 2 more
you want to configure speakers to 5.1ch, for
enhanced surround.
ui
using .
Speaker Connection
7.1ch is selected for speaker
system. Select "Yes" to confirm.
Move to the item that
Yes
you want to configure
o p
using .
Speaker Connection
Please connect the
speakers.
Location :CENTER
Terminal :CENTER
Press [ENTER] for next
connection.
Enters the selection.
Ready to connect
Setup Wizard
Do you wish to stop
and exit wizard?
You can restart the
setup wizard anytime
using the on screen
menu.
Returns to the start of
each setting.
or
Cancels the Setup
Wizard.
SVENSKA NEDErlANDS
1
Insert the main unit power plug into the wall
socket.
To household power outlet
(AC 230 V, 50/60 Hz)
2
AMP
Press
No
operation mode.
Switch the AMP-operation mode
• This remote control is a preset remote control that can be used to
control connected devices.
Yes
When power is switched to standby
No
STANDBY X
Press ( ).
GPower indicator status in standby modeH
• Normal standby : Red
• When "HDMI Control"(vm page 90) is
set to "ON" : Orange
• When "Network Standby"(vm page 94)
is set to "ON" : Orange
NOTE
During power standby, a minimal amount of power is consumed. To
totally cut off the power, remove the power cord from the power
outlet.
ESpAñol itAliANo

Getting Started

Power cord (Supplied)
to set the remote control unit to AMP-
FrANçAiS DEutSch
3
Z
Press ON ( ) on this unit.
The power switches on, and the Setup Wizard start screen is
displayed on the television screen.
Power on
Setup Wizard
This wizard assists 1. Language Select
connection and setup
2. Speaker Connection
of receiver step by
step using cursor,
3. Speaker Calibration
enter or return keys
4. Source Setup
on remote.
Press [ENTER] to start.
5. Network Setup
Start
Complete
4
Press ENTER .
Start the Setup Wizard.
Setup Wizard has started.
Please follow the message on screen.
To start the Setup Wizard again after exiting it, select "Setup
Wizard" in the menu (vm page 75 "Menu map").
ENGliSh
5